NOTE #1: This vehicle is with MAZDA'S TRANSPONDER ANTI-THEFT SYSTEM,
for REMOTE STARTING ONLY you will need the Part #791 BYPASS Module and an
Extra Ignition key. (Requires extra key for Operation)
Part # PK-ALL or PKFM for REMOTE STARTING ONLY, requires 2 keys for
programming, NO key required for Operation.
Part # DB-ALL for Remote Starting and Keyless Entry operation (no resistors
required), 2 keys required for programming, no key required for Operation.
To Order the go to the SECURITY BYPASS MODULE Page or INTERFACE BYPASS
MODULE Page on this website.
NOTE #2: the BCM, (Body Control Module) is located UNDER the DRIVERS DASH, above the
DRIVERS KICK PANEL.
NOTE #3: This Vehicle requires the INTERFACE BYPASS MODULE DB-ALL for KEYLESS ENTRY
OPERATION
NOTE #4: this Vehicle requires the INTERFACE BYPASS MODULE DB-ALL for KEYLESS ENTRY
Operation
NOTE #5: TEST this wire while Opening the Trunk/Liftgate from the Release Button on the
REAR of the Vehicle.
NOTE #6: On vehicles with the PUSH-BUTTON Start, the START 1 and 2 wires are LT. GREEN (-)
and PURPLE (-) at the ENGINE START/STOP Switch, (12-PIN PLUG), PINS A and B
NOTE #7: On vehicles with the PUSH-BUTTON Start, this wire is located at the RELAY BLOCK,
(6-PIN PLUG), PIN B. The RELAY BLOCK is located under the DRIVERS DASH and to
the LEFT of the Steering Column.
NOTE #8: On vehicles with the PUSH-BUTTON Start, this wire is located at the RELAY BLOCK,
(6-PIN PLUG), PIN F. The RELAY BLOCK is located under the DRIVERS DASH and to
the LEFT of the Steering Column.
NOTE #9: On vehicles with the PUSH-BUTTON Start, this wire is located at the RELAY BLOCK,
(8-PIN PLUG), PIN B. The RELAY BLOCK is located under the DRIVERS DASH and to
the LEFT of the Steering Column.
|