Mazda  Mazda 3 2004-2006
 PART   COLOR  LOCATION
 12 VOLT CONSTANT   RED (+) and BLACK/RED (+)   @ NITION SWITCH HARNESS
 STARTER  GRAY/BLACK (+)  @ IGNITION SWITCH HARNESS
 STARTER 2  N/A  
 IGNITION 1  GREEN/YELLOW (+)  @ IGNITION SWITCH HARNESS
 IGNITION 2  N/A  
 IGNITION 3  N/A  
 ACCESSORY/HEATER BLOWER 1  PINK/YELLOW (+)  @ IGNITION SWITCH HARNESS
 ACCESSORY/HEATER BLOWER 2  YELLOW (+)  @ IGNITION SWITCH HARNESS
 KEYSENSE  RED/BLACK (+)  @ IGNITION SWITCH HARNESS
 PARKING LIGHTS ( - )  BLACK/WHITE (-)  @ HEADLIGHT SWITCH
 PARKING LIGHTS ( + )  ORANGE/WHITE (+) and ORANGE (+) Use Both, See NOTE #2  IN PASSENGER KICK PANEL
 POWER LOCK  GREEN/RED (1-Wire Door Lock System) See NOTE #3  IN DRIVERS KICK PANEL, See DIAGRAM
 POWER UNLOCK  Same wire, See DIAGRAM  See DIAGRAMS
 DOOR TRIGGER  See NOTE #4  IN PASSENGER KICK PANEL
 DOMELIGHT SUPERVISION  BLACK/BLUE to BLACK/RED (-), Requires Part #775 Relay  IN PASSENGER KICK PANEL, Harness to REAR of VEHICLE.
 TRUNK RELEASE  N/A  
 SLIDING POWER DOOR  N/A  
 HORN  BLACK (-)  @ STEERING COLUMN HARNESS
 TACH  Any wire NOT GREEN/STRIPE  @ IGNITION COIL
 WAIT TO START LIGHT  N/A  
 BRAKE  RED/WHITE (+)  @ SWITCH ABOVE BRAKE PEDAL
 FACTORY ALARM DISARM   BLACK/WHITE (-)  IN DRIVERS KICK PANEL, HARNESS TO REAR OF VEHICLE
 ANTI-THEFT  TRANSPONDER ANTI-THEFT SYSTEM, See NOTE #1  TRANSPONDER @ IGNITION SWITCH TUMBLER
 EXTRA INFORMATION
 NOTE #1: This vehicle is with MAZDA'S TRANSPONDER ANTI-THEFT SYSTEM, for REMOTE STARTING ONLY you will need the Part #791 BYPASS Module and an Extra Ignition key. (Requires extra key for Operation) Part # PK-ALL or PKFM for REMOTE STARTING ONLY, requires 2 keys for programming, NO key required for Operation. Part # DB-ALL for Remote Starting and Keyless Entry operation (no resistors required), 2 keys required for programming, no key required for Operation. To Order the go to the SECURITY BYPASS MODULE Page or INTERFACE BYPASS MODULE Page on this website. NOTE #2: the (+)Positive PARKING LIGHT Circuit on this vehicle uses (2) PARKING LIGHT wires, to make this connection will require 2 Extra Relays Part #775, to connect, See DIAGRAM NOTE #3: to LOCK requires a (-)Negative thru a 1000 Ohm Resistor, to UNLOCK requires a Straight (-)Negative. Some units will also require 2 extra Relays part #775 to make this connection, See DIAGRAMS NOTE #4: THE LEFT FRONT DOOR IS BLACK/YELLOW (-) ,THE RIGHT FRONT DOOR IS BLACK/BLUE (-),AND THE RIGHT REAR DOOR IS BLACK/GREEN (-),THE LEFT REAR DOOR IS BLACK/ORANGE (-).WHEN CONNECTING TO AN ALARM SYSTEM, USE ALL 4 DOOR TRIGGER WIRES AND DIODE ISOLATE, TO CONNECT, SEE DIAGRAM.