Mazda  Cx-9 2009-2011
 PART   COLOR  LOCATION
 12 VOLT CONSTANT   RED (+)   @ IGNITION SWITCH, (6-PIN PLUG), PIN F
 STARTER  BLACK/BLUE (+)  @ IGNITION SWITCH, (6-PIN PLUG), PIN A
 STARTER 2  N/A  
 IGNITION 1  BLUE (+)  @ IGNITION SWITCH, (6-PIN PLUG), PIN C
 IGNITION 2  N/A  
 IGNITION 3  N/A  
 ACCESSORY/HEATER BLOWER 1  BLACK/RED (+)  @ IGNITION SWITCH, (6-PIN PLUG), PIN B
 ACCESSORY/HEATER BLOWER 2  BLACK/WHITE (+)  @ IGNITION SWITCH, (6-PIN PLUG), PIN D
 KEYSENSE  N/A  
 PARKING LIGHTS ( - )  BROWN or BROWN/WHITE (-)  @ HEADLIGHT SWITCH, (17-PIN PLUG), PIN L
 PARKING LIGHTS ( + )  LT. GREEN (+)  @ BCM, (24-PIN PLUG(6), PIN D, NOTE #2
 POWER LOCK  PURPLE/WHITE (TYPE B) (-) Negative  @ BCM, (30-PIN PLUG(3), PIN R, NOTE #2
 POWER UNLOCK  Use LOCK wire, See NOTE #3  
 DOOR TRIGGER  GRAY/RED (-)  @ BCM, (24-PIN PLUG(6), PIN O, NOTE #2
 DOMELIGHT SUPERVISION  YELLOW/RED (-)  @ BCM, (8-PIN PLUG(7), PIN I, NOTE #2
 TRUNK RELEASE  WHITE/GREEN and WHITE/BLACK, NOTE #4  @ POWER LIFTGATE Switch, (6-PIN PLUG), PINS A and C
 SLIDING POWER DOOR  N/A  
 HORN  GREEN/RED (-)  @ BCM, (30-PIN PLUG(3), PIN U, NOTE #2
 TACH  Any wire NOT BLUE (AC)  @ Any FUEL-INJECTOR
 WAIT TO START LIGHT  N/A  
 BRAKE  GREEN/YELLOW (+)  @ BRAKE PEDAL SWITCH or in DRIVERS KICK PANEL, Harness to REAR of Vehicle
 FACTORY ALARM DISARM   Disarms with Interface Bypass Module  
 ANTI-THEFT  MAZDA'S TRANSPONDER ANTI-THEFT SYSTEM, See NOTE #1  @ IGNITION SWITCH TUMBLER
 EXTRA INFORMATION
 NOTE #1: This vehicle is with MAZDA'S TRANSPONDER ANTI-THEFT SYSTEM, for REMOTE STARTING ONLY you will need the Part #791 BYPASS Module and an Extra Ignition key. (Requires extra key for Operation) Part # PK-ALL or PKFM for REMOTE STARTING ONLY, requires 2 keys for programming, NO key required for Operation. Part # DB-ALL for Remote Starting and Keyless Entry operation (no resistors required), 2 keys required for programming, no key required for Operation. To Order the go to the SECURITY BYPASS MODULE Page or INTERFACE BYPASS MODULE Page on this website. NOTE #2: the BCM, (Body Control Module) is located in the DRIVERS KICK PANEL. NOTE #3: to connect KEYLESS ENTRY in this vehicle will require the DB-ALL Interface Bypass Module, to order go to the Interface bypass module page on this website NOTE #4: Use a RELAY to SHORT these 2 wires together to Open/Close the Power Liftgate