| PART | COLOR | LOCATION |
| 12 VOLT CONSTANT | YELLOW (+) | @ IGNITION SWITCH HARNESS |
| STARTER | RED/LIGHT BLUE (+) | @ IGNITION SWITCH HARNESS |
| STARTER 2 | N/A | |
| IGNITION 1 | LIGHT GREEN/PURPLE (+) | @ IGNITION SWITCH HARNESS |
| IGNITION 2 | BLACK/GREEN (+) | @ IGNITION SWITCH HARNESS |
| IGNITION 3 | N/A | |
| ACCESSORY/HEATER BLOWER 1 | GRAY/YELLOW (+) | @ IGNITION SWITCH HARNESS |
| ACCESSORY/HEATER BLOWER 2 | N/A | |
| KEYSENSE | N/A | |
| PARKING LIGHTS ( - ) | WHITE/BLACK (-) | @ HEADLIGHT SWITCH |
| PARKING LIGHTS ( + ) | BROWN (+) | IN PIN 8, BROWN PLUG @ SJB, See NOTE #2 |
| POWER LOCK | PINK/YELLOW (TYPE B) | IN PIN 5, LARGE BLACK PLUG @ SJB, See NOTE #2 |
| POWER UNLOCK | PINK/LIGHT GREEN (TYPE B) | IN PIN 9, LARGE BLACK PLUG @ SJB, See NOTE #2 |
| DOOR TRIGGER | See NOTE #3 | @ SJB, See NOTE #2 |
| DOMELIGHT SUPERVISION | BLACK/LIGHT BLUE (+), Requires Part #775 Relay | IN PIN 14, GRAY PLUG @ SJB, See NOTE #2 |
| TRUNK RELEASE | N/A | |
| SLIDING POWER DOOR | N/A | |
| HORN | YELLOW/LIGHT GREEN to DARK BLUE (-) | @ STEERING COLUMN HARNESS |
| TACH | Any wire NOT RED (AC) | @ IGNITION COIL PACK |
| WAIT TO START LIGHT | N/A | |
| BRAKE | LIGHT GREEN (+) | @ SWITCH ABOVE BRAKE PEDAL |
| FACTORY ALARM DISARM | N/A | |
| ANTI-THEFT | FORD'S SECURILOCK ANTI-THEFT TRANSPONDER SYSTEM, SEE NOTE #1 | TRANSPONDER @ IGNITION SWITCH TUMBLER |
| EXTRA INFORMATION |
| NOTE #1: This vehicle May Be Equipped with FORD'S TRANSPONDER ANTI-THEFT SYSTEM, check the OWNERS MANUAL for this vehcile or contact your HYUNDAI Dealer to see if the vehicle has a Special programmed Ignition Key, if it does, then for REMOTE STARTING you will need the 791 BYPASS Module and an Extra Ignition key. To Order the 791 go to the SECURITY BYPASS MODULE Page on this website. NOTE #2: THE SJB ( SMART JUNCTION BOX ) IS THE FUSE/RELAY BOX IN THE PASSENGER KICK PANEL. NOTE #3: THE DRIVERS DOOR TRIGGER IS YELLOW/BLACK (-) IN THE LARGE BLACK PLUG, PIN 6. THE PASSENGER DOOR(S) TRIGGER IS GRAY/RED (-) IN THE SMALL BLACK PLUG, PIN 3. WHEN CONNECTING TO AN ALARM SYSTEM, USE BOTH DOOR TRIGGER WIRES AND DIODE ISOLATE, TO CONNECT, See DIAGRAM. |