PART | COLOR | LOCATION |
12 VOLT CONSTANT | YELLOW (+) and LIGHT GREEN/PURPLE (+) | IGNITION SWITCH HARNESS |
STARTER | RED/LIGHT BLUE (+) | IGNITION SWITCH HARNESS |
STARTER 2 | N/A | |
IGNITION 1 | WHITE/YELLOW (+) | IGNITION SWITCH HARNESS |
IGNITION 2 | PINK/BLACK (+) | IGNITION SWITCH HARNESS |
IGNITION 3 | N/A | |
ACCESSORY/HEATER BLOWER 1 | GREY/YELLOW (+) | IGNITION SWITCH HARNESS |
ACCESSORY/HEATER BLOWER 2 | BLACK/LIGHT GREEN (+) | IGNITION SWITCH HARNESS |
KEYSENSE | N/A | |
PARKING LIGHTS ( - ) | N/A | |
PARKING LIGHTS ( + ) | BROWN (+) (Thin Gauge wire) | @ LCM, See NOTE *1 |
POWER LOCK | PINK/YELLOW (TYPE A) | IN DRIVERS DOOR HARNESS, See NOTE *6 |
POWER UNLOCK | PINK/LIGHT GREEN (TYPE A) | IN DRIVERS DOOR HARNESS, See NOTE *6 |
DOOR TRIGGER | BLUE (-) and BLACK/ORANGE (-) Use both, See NOTE *5 | @ DRIVERS DOOR Module, See NOTE *3 |
DOMELIGHT SUPERVISION | BLACK/LIGHT BLUE (+), Requires Part #775 Relay | @ the DRIVERS side UNDER DASH LIGHT or @ LCM Module, See NOTE *1 |
TRUNK RELEASE | RED (5-Wire) See NOTE *2, Requires Part #775 Relay | IN DRIVERS DOOR HARNESS, LOW IN DRIVERS KICK PANEL |
SLIDING POWER DOOR | N/A | |
HORN | DARK BLUE (-) (Thin Gauge wire) | @ LCM Module, See NOTE *1 |
TACH | GREEN/WHITE or GREEN/YELLOW | See NOTE *4 |
WAIT TO START LIGHT | N/A | |
BRAKE | RED/LIGHT GREEN (+) (Thin Gauge wire) | @ LCM Module, See NOTE *1 |
FACTORY ALARM DISARM | N/A | |
ANTI-THEFT | FORD'S PATS ANTI-THEFT TRANSPONDER SYSTEM | TRANSPONDER @ IGNITION SWITCH TUMBLER |
EXTRA INFORMATION |
NOTE *1 the LCM (Lighting Control Module) is located to the RIGHT of the STEERING COLUMN. NOTE *2 this vehicle uses a 5-wire TRUNK RELEASE SYSTEM, that will require an extra Relay Part #775, to connect, See DIAGRAM. NOTE *3 the DRIVERS DOOR Module is located below the mirror in the Drivers door. NOTE *4 the TACH wire is located at the front of the motor, the coil is on the first spark plug on the drivers side. NOTE *5 this vehicle has 2 DOOR TRIGGER wires, when connecting to an ALARM SYSTEM, use both DOOR TRIGGER wires and DIODE ISOLATE, to connect, See DIAGRAM NOTE *6 the DOOR HARNESS when it comes into the vehicle goes up into the KICK PANEL and it is hard to get these wires there, the easiest place to catch theLOCK and UNLOCK wires are in the DOOR JAM BOOT, between the DOOR and the "A" Piller inside the boot. |