Lexus Lx570 2008-2011 Printer Friendly Wiring Chart

Lexus Lx570 2008-2011

PART	COLOR	LOCATION
12 VOLT CONSTANT	BLACK (+)	@ DRIVERS DASH FUSE BOX, (WHITE, 1-PIN PLUG(A) PIN 1
STARTER	BLACK (-) and BLACK (-)	@ ENGINE SWITCH, (BLACK, 14-PIN PLUG) PINS 7 and 2
STARTER 2	RED (+)	@ BECU, (WHITE, 10-PIN PLUG) PIN 4, NOTE #3
IGNITION 1	BLACK (+)	@ BECU, (WHITE, 28-PIN PLUG) PIN 11, NOTE #3
IGNITION 2	GREEN (+)	@ BECU, (WHITE, 26-PIN PLUG) PIN 3, NOTE #3
IGNITION 3	N/A
ACCESSORY/HEATER BLOWER 1	PINK (+)	@ BECU, (WHITE, 26-PIN PLUG) PIN 22, NOTE #3
ACCESSORY/HEATER BLOWER 2	N/A
KEYSENSE	N/A
PARKING LIGHTS ( - )	PURPLE (-)	@ BECU, (WHITE, 26-PIN PLUG) PIN 23, NOTE #3
PARKING LIGHTS ( + )	GREEN (+)	@ DRIVERS DASH FUSE BOX, (WHITE, 24-PIN PLUG(C) PIN 22
POWER LOCK	RED (TYPE B), (TEST with PASSENGER Switch) NOTE #4	@ DRIVERS DASH FUSE BOX, (REAR, WHITE, 66-PIN PLUG(D) PIN 49
POWER UNLOCK	GREEN (TYPE B), (TEST with PASSENGER Switch) NOTE #5	@ DRIVERS DASH FUSE BOX, (REAR, WHITE, 66-PIN PLUG(D) PIN 52
DOOR TRIGGER	BLUE (-)	@ BECU, (WHITE, 26-PIN PLUG) PIN 24, NOTE #3
DOMELIGHT SUPERVISION	Use DOOR TRIGGER
TRUNK RELEASE	BLUE (-) NOTE #7	@ BECU, (WHITE, 26-PIN PLUG) PIN 26, NOTE #3
SLIDING POWER DOOR	N/A
HORN	RED/WHITE (-)	@ DRIVERS DASH FUSE BOX, (WHITE, 24-PIN PLUG(B) PIN 1
TACH	WHITE (AC)	@ DATA LINK Connector, (WHITE, 16-PIN PLUG) PIN 9, under Drivers Dash
WAIT TO START LIGHT	N/A
BRAKE	RED (+)	@ DRIVERS DASH FUSE BOX, (WHITE, 24-PIN PLUG(B) PIN 22
FACTORY ALARM DISARM	YELLOW (-) Requires Double Pulse, NOTE #2	in DRIVERS KICK PANEL, (WHITE, 18-PIN PLUG) PIN 14
ANTI-THEFT	TOYOTA'S TRANSPONDER SYSTEM, See NOTE #1

EXTRA INFORMATION

NOTE #1: LEXUS TRANSPONDER ANTI-THEFT SYSTEM, Requires Bypass Module, Part # 791 Bypass Module (for REMOTE STARTING ONLY!) an Extra Ignition key is required to be placed inside this module for Operation. Part # PK-ALL Bypass Module (for REMOTE STARTING ONLY!) KEYLESS BYPASS NO KEY is required for Operation. Part # DB-ALL Bypass Module, this Module is a KEYLESS BYPASS MODULE and DOES NOT require a Key to be placed inside the Module for Operation, this module will also do the Keyless Entry. To order the Bypass Module go to the INTERFACE BYPASS MODULE Page on this website NOTE #2: TEST this wire while turning the Key in the Drivers Door. NOTE #3: the BECU, (Body Electronic Control Unit) is located under the DRIVERS Dash and attached to the Right side of the Drivers Dash FUSE BOX. NOTE #4: this wire is only needed if the Door Locks do not function with the Aftermarket System while the vehicle is running. All other times just use the Factory Alarm Arm wire. NOTE #5: this wire is only needed if the Door Locks do not function with the Aftermarket System while the vehicle is running. All other times just use the Factory Alarm Disarm wire. NOTE #6: the FRONT CONTROLLER is located under the RIGHT FRONT Corner of the ENGINE COMPARTMENT, next to the ENGINE COMPARTMENT FUSE BOX. NOTE #7: TEST this wire while opening the Liftgate from the Handle on the Rear of the Vehicle. on vehicles with POWER LIFTGATE, the open/close wire is a RED (-) at the Switch on the Dash or BECU, (WHITE, 28-PIN PLUG) PIN 2.