Lexus IS250 2006-2008 Printer Friendly Wiring Chart

Lexus IS250 2006-2008

PART	COLOR	LOCATION
12 VOLT CONSTANT	WHITE (+)	@ DRIVERS FUSE BOX, 1-PIN PLUG
STARTER	BLACK (-)	@ POWER SWITCH, (BLACK, 14-PIN PLUG) PIN 7 or PSCM, (40-PIN PLUG) PIN 14, NOTE #5
STARTER 2	LT. BLUE (-)	@ POWER SWITCH, (BLACK, 14-PIN PLUG) PIN 2 or PSCM, (40-PIN PLUG) PIN 37, NOTE #5
IGNITION 1	LT. GREEN (+) (NOT for REMOTE START)	@ PSCM, (40-PIN PLUG) PIN 35, NOTE #5
IGNITION 2	PINK (+) (NOT for REMOTE START)	@ PSCM, (40-PIN PLUG) PIN 34, NOTE #5
IGNITION 3	N/A
ACCESSORY/HEATER BLOWER 1	LT. GREEN (+) (NOT for REMOTE START)	@ PSCM, (40-PIN PLUG) PIN 11, NOTE #5
ACCESSORY/HEATER BLOWER 2	N/A
KEYSENSE	N/A
PARKING LIGHTS ( - )	YELLOW (-)	@ DRIVERS FUSE BOX, 28-PIN PLUG, PIN 5
PARKING LIGHTS ( + )	BROWN (+) (Rear) NOTE #6	@ DRIVERS FUSE BOX, (GRAY, 30-PIN PLUG), PIN 24
POWER LOCK	BROWN (TYPE B), NOTE #2	@ PASSENGER FUSE BOX, (GRAY, 30-PIN PLUG) PIN 7
POWER UNLOCK	BLACK (TYPE B), NOTE #3	@ PASSENGER FUSE BOX, (GRAY, 30-PIN PLUG) PIN 10
DOOR TRIGGER	WHITE to RED (-)	@ BECU (RH), (16-PIN PLUG) PIN 14, NOTE #7
DOMELIGHT SUPERVISION	PURPLE to PINK (-)	@ BECU (LH), (10-PIN PLUG) PIN 2, NOTE #8
TRUNK RELEASE	PINK (-)	@ SWITCH or BECU (RH), (28-PIN PLUG) PIN 3, NOTE #7
SLIDING POWER DOOR	N/A
HORN	WHITE (-)	@ HORN SWITCH, under Steering Column Cover
TACH	WHITE (AC)	@ DATA LINK Connector, Pin 9, under Dash
WAIT TO START LIGHT	N/A
BRAKE	RED/BLACK (+)	@ BRAKE SWITCH, above Brake Pedal
FACTORY ALARM DISARM	WHITE (-) Requres Double Pulse, NOTE #4	@ POWER WINDOW SWITCH, (20-PIN PLUG) PIN 14
ANTI-THEFT	TOYOTA'S TRANSPONDER SYSTEM, See NOTE #1

EXTRA INFORMATION

NOTE #1: TOYOTA'S TRANSPONDER ANTI-THEFT SYSTEM, Requires part #791 Bypass Module and an extra ignition key for remote starting. Part # PK-ALL Bypass, NO EXTRA KEY REQUIRED!! To order go to the INTERFACE Bypass Module Page on this website. NOTE #2: this wire is only needed if the Door Locks do not function with the Aftermarket System while the vehicle is running. All other times just use the Factory Alarm Arm wire. NOTE #3: this wire is only needed if the Door Locks do not function with the Aftermarket System while the vehicle is running. All other times just use the Factory Alarm Disarm wire. NOTE #4: TEST this wire while turning the Key in the Drivers Door, this wire will also Unlock the Doors. NOTE #5: the PSCM (Power Source Control Module) is located behind the GLOVE BOX. NOTE #6: the FRONT PARKING LIGHT wire is a BLUE (+) @ the DRIVERS side HEADLIGHT Assembly. NOTE #7: the BECU (RH) (Body Electronic Control Unit ( Right Hand) is part of the PASSENGER side FUSE BOX, located behind the GLOVE BOX. NOTE #8: the BECU (LH) (Body Electronic Control Unit ( Left Hand) is part of the DRIVERS side FUSE BOX, located under the Drivers side of the Dash.