Lexus Gs450h 2009-2010 Printer Friendly Wiring Chart

Lexus Gs450h 2009-2010

PART	COLOR	LOCATION
12 VOLT CONSTANT	WHITE (+)	@ DRIVERS DASH FUSE BOX, (WHITE, 1-PIN PLUG) PIN 1
STARTER	PINK (-)	@ ENGINE SWITCH, (BLACK, 14-PIN PLUG) PIN 7
STARTER 2	BLACK (-)	@ ENGINE SWITCH, (BLACK, 14-PIN PLUG) PIN 2
IGNITION 1	WHITE (+)	@ PASSENGER DASH FUSE BOX, (GRAY, 10-PIN PLUG(K), PIN 3
IGNITION 2	LT. BLUE (+)	@ PASSENGER DASH FUSE BOX, (REAR, WHITE, 32-PIN PLUG), PIN 6
IGNITION 3	N/A
ACCESSORY/HEATER BLOWER 1	LT. BLUE (+)	@ PASSENGER DASH FUSE BOX, (REAR, WHITE, 32-PIN PLUG), PIN 2
ACCESSORY/HEATER BLOWER 2	N/A
KEYSENSE	N/A
PARKING LIGHTS ( - )	BLUE (-)	@ HEADLIGHT SWITCH, (20-PIN PLUG) PIN 18
PARKING LIGHTS ( + )	GREEN (+) (FRONT), NOTE #9	@ (LH) HEADLIGHT Assembly or ENGINE Compartment FUSE BOX, (BLACK, 13-PIN PLUG), PIN 9
POWER LOCK	BLUE (-TYPE B), (TEST wih PASSENGER Switch) NOTE #2	@ FRONT (RH) DOR ECU, (WHITE, 24-PIN PLUG) PIN 22
POWER UNLOCK	GREEN (TYPE B), (TEST wih PASSENGER Switch) NOTE #3	@ FRONT (RH) DOOR ECU, (WHITE, 24-PIN PLUG) PIN 23
DOOR TRIGGER	RED (-)	@ BECU (RH), (WHITE, 16-PIN PLUG) PIN 14, NOTE #7
DOMELIGHT SUPERVISION	BLUE (-)	@ BECU (LH), (WHITE, 10-PIN PLUG) PIN 2, NOTE #7
TRUNK RELEASE	BLUE (-)	@ RELEASE SWITCH, (BLACK,5-PIN PLUG) PIN 4 or BECU (RH), (WHITE, 26-PIN PLUG) PIN 21, NOTE #7
SLIDING POWER DOOR	N/A
HORN	YELLOW (-)	@ HORN SWITCH, (BLACK, 12-PIN PLUG), PIN 8
TACH	WHITE (AC)	@ DATA LINK Connector, (WHITE, 16-PIN PLUG) PIN 9, under Drives Dash
WAIT TO START LIGHT	N/A
BRAKE	RED/BLACK (+)	@ BRAKE SWITCH or PASSENGER DASH FUSE BOX, (GRAY, 10-PIN PLUG(K) PIN 1
FACTORY ALARM DISARM	PINK (-) Requires Double Pulse, NOTE #4	@ POWER WINDOW MASTER SWITCH, (WHITE, 20-PIN PLUG) PIN 13
ANTI-THEFT	TOYOTA'S TRANSPONDER SYSTEM, See NOTE #1

EXTRA INFORMATION

NOTE #1: LEXUS TRANSPONDER ANTI-THEFT SYSTEM, Requires Bypass Module, Part # 791 Bypass Module (for REMOTE STARTING ONLY!) an Extra Ignition key is required to be placed inside this module for Operation. Part # PK-ALL Bypass Module (for REMOTE STARTING ONLY!) KEYLESS BYPASS NO KEY is required for Operation. To order the Bypass Module go to the INTERFACE BYPASS MODULE Page on this website NOTE #2: this wire is only needed if the Door Locks do not function with the Aftermarket System while the vehicle is running. All other times just use the Factory Alarm Arm wire. NOTE #3: this wire is only needed if the Door Locks do not function with the Aftermarket System while the vehicle is running. All other times just use the Factory Alarm Disarm wire. NOTE #4: TEST this wire while turning the Key in the Drivers Door, this wire will also Unlock the Doors. NOTE #5: the PSCU, (Power Source Control Unit) is the Module, to the far RIGHT, behind the GLOVE BOX. NOTE #6: TEST this wire while opening the Trunk with the Handle on the Rear of the vehicle. NOTE #7: the BECU (RH) (Body Electronic Control Unit) (Right Hand) is part of the PASSENGER SIDE FUSE BOX, on the Right Side. NOTE #8: the BECU (LH) (Body Electronic Control Unit) (Left Hand) is on the Right side of the DRIVERS SIDE FUSE BOX, under the DRIVERS DASH NOTE #9: the REAR (LH) PARKING LIGHT is a PURPLE (+) and (RH) PARKING LIGHT is a BROWN (+), @ the LUGGAGE Compartment FUSE BOX, (WHIE, 22-PIN PLUG) PINS 8 and 22