NOTE #1: LEXUS TRANSPONDER ANTI-THEFT SYSTEM, Requires Bypass Module,
Part # 791 Bypass Module (for REMOTE STARTING ONLY!) an Extra Ignition key is
required to be placed inside this module for Operation.
Part # PK-ALL Bypass Module (for REMOTE STARTING ONLY!) KEYLESS BYPASS
NO KEY is required for Operation.
To order the Bypass Module go to the INTERFACE BYPASS MODULE Page on this
website
NOTE #2: the PSC, ECU (Electronic Control Unit) is located on the FAR RIGHT (PASSENGER SIDE) behind the GLOVE BOX.
NOTE #3: when testing the LOCK and UNLOCK wires, make sure you meter them while turning the key in the drivers door key cylinder.
NOTE #4: the DRIVERS DOOR is a RED (-) at the BECU (RH) 16-Pin Plug, Pin 14, the PASSENGER DOOR is a RED (-) at the BECU (RH) 28-Pin Plug, Pin 23, the DRIVERS REAR DOOR is a GREEN (-) at the PASSENGER SIDE FUSEBOX, 28-Pin Plug, Pin 23 and the PASSENGER REAR DOOR is a BLUE (-) at the BECU, (RH) 16-Pin Plug, Pin 16. When connecting to an ALARM SYSTEM, use all 4 DOOR TRIGGER wires and DIODE ISOLATE, to connect, See DIAGRAM.
NOTE #5: the BECU (LH) is attached to the DRIVERS SIDE FUSEBOX, under the DRIVERS SIDE of the DASH. The BECU (RH) is attached to the PASSENGER SIDE FUSEBOX, behind the GLOVE BOX.
NOTE #6: test this TRUNK/HATCH RELEASE wire while opening the trunk from the handle on the trunk.
NOTE #7: the DATA LINK Connector is located under the DRIVERS SIDE of the DASH.
|