| PART | COLOR | LOCATION |
| 12 VOLT CONSTANT | WHITE/RED (+) | @ IGNITION SWITCH HARNESS |
| STARTER | BLACK/WHITE (+) Must use BOTH Starter | @ IGNITION SWITCH HARNESS |
| STARTER 2 | GREEN/YELLOW (+) wires for Remote Starting!!! | @ IGNITION SWITCH HARNESS |
| IGNITION 1 | BLACK/RED (+) | @ IGNITION SWITCH HARNESS |
| IGNITION 2 | BLACK/YELLOW (+) | @ IGNITION SWITCH HARNESS |
| IGNITION 3 | N/A | |
| ACCESSORY/HEATER BLOWER 1 | BLUE/RED (+) | @ IGNITION SWITCH HARNESS |
| ACCESSORY/HEATER BLOWER 2 | N/A | |
| KEYSENSE | BLUE (-) | @ IGNTION SWITCH HARNESS |
| PARKING LIGHTS ( - ) | RED (-) | @ HEADLIGHT SWITCH or PIN 8 IN 22 PIN PLUG AT BECU See NOTE #2 |
| PARKING LIGHTS ( + ) | GREEN (+) | @ PIN 19 IN 20 PIN PLUG BOTTOM OF FUSEBOX |
| POWER LOCK | BLUE/YELLOW (TYPE B) | @ PIN 4 AT ECU INSIDE DRIVERS DOOR |
| POWER UNLOCK | BLUE (TYPE B) REQUIRES DOUBLE PULSE | @ PIN 14 AT ECU INSIDE DRIVERS DOOR |
| DOOR TRIGGER | See NOTE #3 | @ BECU, See NOTE #2 |
| DOMELIGHT SUPERVISION | GREEN/RED (-) | IN DRIVERS A PILLAR, 13-Pin Plug, Pin 8 |
| TRUNK RELEASE | RED (-) or BLUE/YELLOW (-) | @ TRUNK RELEASE SWITCH or BECU, 18-Pin Plug, Pin 5 |
| SLIDING POWER DOOR | N/A | |
| HORN | GREEN/BLACK (-) | @ BOTTOM of FUSEBOX, 24-Pin Plug, Pin 22 |
| TACH | BLACK/ORANGE | PIN 5 CONNECTOR E6 AT ECM See NOTE #4 |
| WAIT TO START LIGHT | N/A | |
| BRAKE | GREEN/WHITE (+) | PIN 15 IN 20 PIN PLUG BOTTOM OF FUSEBOX |
| FACTORY ALARM DISARM | DISARMS with KEYSENSE wire See NOTE #5 | |
| ANTI-THEFT | TRANSPONDER ANTI-THEFT SYSTEM, REQUIRES 791 BYPASS MODULE AND EXTRA IGNITION KEY | TRANSPONDER @ IGNITION SWITCH TUMBLER |
| EXTRA INFORMATION |
| NOTE #1: LEXUS TRANSPONDER ANTI-THEFT SYSTEM, Requires Bypass Module, Part # 791 Bypass Module (for REMOTE STARTING ONLY!) an Extra Ignition key is required to be placed inside this module for Operation. Part # PK-ALL Bypass Module (for REMOTE STARTING ONLY!) KEYLESS BYPASS NO KEY is required for Operation. To order the Bypass Module go to the INTERFACE BYPASS MODULE Page on this website NOTE #2: THE BECU IS ATTACHED TO THE BACK OF THE FUSEBOX.IT HAS THREE PLUGS ON THE LEFT SIDE EDGE. NOTE #3: THE DRIVERS DOOR TRIGGER IS RED/GREEN (-) PIN 1 IN 12 PIN PLUG.THE OTHER THREE DOOR TRIGGER WIRES ARE IN THE 22 PIN PLUG.THE FRONT PASSENGER DOOR IS RED/GREEN (-) PIN 11,THE LEFT REAR DOOR IS RED/WHITE (-) IN PIN 12,AND THE RIGHT REAR DOOR IS RED/YELLOW (-) IN PIN 14.WHEN CONNECTING TO AN ALARM SYSTEM, USE ALL 4 WIRES AND DIODE ISOLATE EACH See DIAGRAM. NOTE #4: THE ECM IS LOCATED BEHIND THE GLOVEBOX.CONNECTOR E6 IS THE TOP PLUG. NOTE #5: the vehicle can be disarmed without unlocking by attaching a (-) Negative output wire to the BLUE (-) KEYSENSE wire in the IGNITION SWITCH HARNESS. |