| PART | COLOR | LOCATION |
| 12 VOLT CONSTANT | WHITE/RED (+) | @ IGNITION SWITCH HARNESS |
| STARTER | BLACK/WHITE (+) Must use BOTH Starter | @ IGNITION SWITCH HARNESS |
| STARTER 2 | GREEN/YELLOW (+) wires for Remote Starting!!! | @ IGNITION SWITCH HARNESS |
| IGNITION 1 | BLACK/RED (+) | @ IGNITION SWITCH HARNESS |
| IGNITION 2 | BLACK/YELLOW (+) | @ IGNITION SWITCH HARNESS |
| IGNITION 3 | N/A | |
| ACCESSORY/HEATER BLOWER 1 | BLUE (+) | @ IGNITION SWITCH HARNESS |
| ACCESSORY/HEATER BLOWER 2 | N/A | |
| KEYSENSE | N/A | |
| PARKING LIGHTS ( - ) | RED (-) | @ HEADLIGHT SWITCH |
| PARKING LIGHTS ( + ) | GREEN (+) | @ BOTTOM OF FUSEBOX |
| POWER LOCK | BLUE/YELLOW (TYPE B) | @ DRIVERS DOOR MODULE in DRIVERS DOOR |
| POWER UNLOCK | BLUE (TYPE B) REQUIRES DOUBLE PULSE | @ DRIVERS DOOR MODULE in DRIVERS DOOR |
| DOOR TRIGGER | See NOTE #2 | |
| DOMELIGHT SUPERVISION | TURNS ON with UNLOCK | |
| TRUNK RELEASE | WHITE/BLUE (5-WIRE) See DAIGRAM, Requires Part #775 Relay | IN DRIVERS KICK PANEL |
| SLIDING POWER DOOR | N/A | |
| HORN | GREEN/BLACK (-) | @ STEERING COLUMN HARNESS |
| TACH | BLACK/ORANGE (AC) | PIN 5 @ 31 PIN PLUG @ ECM See NOTE #3 |
| WAIT TO START LIGHT | N/A | |
| BRAKE | GREEN/WHITE (+) | @ SWITCH ABOVE BRAKE PEDAL |
| FACTORY ALARM DISARM | N/A | |
| ANTI-THEFT | LEXUS TRANSPONDER ANTI-THEFT SYSTEM, See NOTE #1 | TRANSPONDER @ IGNITION SWITCH TUMBLER |
| EXTRA INFORMATION |
| NOTE #1: LEXUS TRANSPONDER ANTI-THEFT SYSTEM, Requires Bypass Module, Part # 791 Bypass Module (for REMOTE STARTING ONLY!) an Extra Ignition key is required to be placed inside this module for Operation. Part # PK-ALL Bypass Module (for REMOTE STARTING ONLY!) KEYLESS BYPASS NO KEY is required for Operation. To order the Bypass Module go to the INTERFACE BYPASS MODULE Page on this website NOTE #2: THE DRIVERS DOOR TRIGGER IS RED/GREEN (-) LOWER LEFT OF THE FUSEBOX.THE PASSENGER DOOR IS RED/GREEN (-) AT UPPER LEFT OF THE FUSEBOX.THE LEFT REAR DOOR TRIGGER IS RED/WHITE (-) ,AND THE RIGHT REAR IS RED/YELLOW (-) AT AT BOTTOM OF FUSEBOX. WHEN CONNECTING TO AN ALARM SYSTEM, USE ALL 4 WIRES AND DIODE ISOLATE EACH, SEE DIAGRAM. NOTE #3: THE ECM IS BEHIND THE GLOVEBOX. |