NOTE *1 the IPM ( Instrument Panel Module) is attached to the FUSEBOX under the DRIVERS SIDE of the DASH.
NOTE *2 to LOCK use the ORANGE (-) FACTORY ALARM ARM wire located at the Power Window switch in the Drivers Door, to UNLOCK use the UNLOCK MOTOR wire PINK (type c) wire located at the Drivers Power window switch Connector 1 Pin 4, this will UNLOCK ONLY the Drivers door. To UNLOCK the other doors, use a Double pulse on the Factory Disarm wire a RED (-) wire at the Drivers Power window switch Connector 2 Pin 1, test this wire, it will show GROUND when you UNLOCK with the Key in the Drivers door.OR YOU CAN USE A BYPASS MODEL XK01 WITH KIADL 1.0 FIRMWARE.
NOTE *3 the DDM (Drivers Door Module) is attached to the Power Window switch in the drivers door.
NOTE *4 the RAM (Rear Area Module) is attached to the FUSEBOX in the Drivers Side of the Cargo Area.
NOTE #5: This vehicle May Be Equipped with KIA'S TRANSPONDER ANTI-THEFT SYSTEM,
check the OWNERS MANUAL for this vehcile or contact your HYUNDAI Dealer to see if
the vehicle has a Special programmed Ignition Key, if it does, then for REMOTE
STARTING you will need the 791 BYPASS Module and an Extra Ignition key.
To Order the 791 go to the SECURITY BYPASS MODULE Page on this website.
|