Jeep Wrangler 2007-2011 Printer Friendly Wiring Chart

Jeep Wrangler 2007-2011

PART	COLOR	LOCATION
12 VOLT CONSTANT	RED(+)	@ BATTERY or TIPM, NOTE #3
STARTER	See NOTE #1
STARTER 2	N/A
IGNITION 1	PINK/WHITE (+)	@ IGNITION SWITCH, (BLACK, 5-PIN PLUG) PIN 3
IGNITION 2	N/A
IGNITION 3	N/A
ACCESSORY/HEATER BLOWER 1	See NOTE #1
ACCESSORY/HEATER BLOWER 2	N/A
KEYSENSE	N/A
PARKING LIGHTS ( - )	N/A
PARKING LIGHTS ( + )	WHITE/ORANGE(+) (Left) and WHITE/PURPLE(+) (Right)	in PASSENGER KICK PANEL or TIPM (BROWN PLUG) PINS 8 and 36, NOTE #3
POWER LOCK	PURPLE/LT. GREEN (-) thru a 330 Ohm Resistor, SEE NOTE #2	in DRIVERS KICK PANEL or TIPM (WHITE PLUG) PIN 2 NOTE #3, see diagram
POWER UNLOCK	USE LOCK WIRE, (-) thru a 100 Ohm Resistor, SEE NOTE #2	see diagram
DOOR TRIGGER	PURPLE (-)	in DRIVERS KICK PANEL or TIPM (WHITE PLUG) PIN 11, NOTE #3
DOMELIGHT SUPERVISION	YELLOW/WHITE (+)	in PASSENGER KICK PANEL or INSTRUMENT CLUSTER, (BROWN, 20-PIN PLUG) PIN 4
TRUNK RELEASE	N/A
SLIDING POWER DOOR	N/A
HORN	DARK GREEN/PURPLE (-)	@ HORN SWITCH or or INSTRUMENT CLUSTER, (BLACK, 20-PIN PLUG) PIN 10
TACH	Any wire NOT BROWN/WHITE (AC)	@ Any FUEL-INJECTOR
WAIT TO START LIGHT	N/A
BRAKE	WHITE/TAN (+)	@ BRAKE SWITCH or TIPM (WHITE PLUG) PIN 10, NOTE #3
FACTORY ALARM DISARM	N/A
ANTI-THEFT	CHRYSLER'S MULTIPLEX IGNITION/TRANSPONDER SYSTEM, See NOTE#1	TRANSPONDER @ IGNITION SWITCH TUMBLER

EXTRA INFORMATION

NOTE #1: This vehicle requires a Special INTERFACE BYPASS MODULE for REMOTE STARTING. Part # DB-ALL or XK09 to bypass this vehciles MULTIPLEX IGNITION/TRANSPONDER System. to order please go to the INTERFACE BYPASS MODULE Page on this website NOTE #2: THIS VEHICLE USES A SINGLE WIRE DOOR LOCKING SYSTEM THAT REQUIRES EXTRA PARTS. SEE DIAGRAM. NOTE #3: THE TIPM (TOTALLY INTEGRATED POWER MODULE) IS LOCATED IN THE ENGINE COMPARTMENT, ON THE PASSENGER FENDER.