Jeep Patriot 2007-2010 Printer Friendly Wiring Chart

Jeep Patriot 2007-2010

PART	COLOR	LOCATION
12 VOLT CONSTANT	RED(+)	@ BATTERY or TIPM, NOTE #3
STARTER
STARTER 2
IGNITION 1	PINK/WHITE (+)	@ IGNITION SWITCH, (BLACK 5-PIN PLUG) PIN 3
IGNITION 2	N/A
IGNITION 3	N/A
ACCESSORY/HEATER BLOWER 1
ACCESSORY/HEATER BLOWER 2	N/A
KEYSENSE	N/A
PARKING LIGHTS ( - )	N/A
PARKING LIGHTS ( + )	WHITE/PURPLE (+)	in DRIVERS KICK PANEL, Harness to Rear of Vehicle
POWER LOCK	LIGHT GREEN/DARK GREEN (-) thru a 330 Ohm Resistor, SEE NOTE #2	in DRIVERS KICK PANEL or INSTRUMENT CLUSTER, (BROWN, 20-PIN PLUG) PIN 18, SEE DIAGRAM
POWER UNLOCK	USE LOCK WIRE (-) thru a 100 Ohm Resistor, SEE NOTE #2	SEE DIAGRAM
DOOR TRIGGER	PURPLE/DK. BLUE (-)	in DRIVERS KICK PANEL or INSTRUMENT CLUSTER, (BROWN, 20-PIN PLUG) PIN 3
DOMELIGHT SUPERVISION	YELLOW/WHITE (+)	in DRIVERS A PILLAR or INSTRUMENT CLUSTER, (BROWN, 20-PIN PLUG) PIN 4
TRUNK RELEASE	N/A
SLIDING POWER DOOR	N/A
HORN	DARK GREEN/PURPLE (-)	@ HORN SWITCH or INSTRUMENT CLUSTER, (BLACK, 20-PIN PLUG) PIN 10
TACH	Any wire NOT DK. BLUE/LT. GREEN (AC)	@ Any FUEL-INJECTOR
WAIT TO START LIGHT	N/A
BRAKE	DARK GREEN/WHITE (+)	@ BRAKE SWITCH or INSTRUMENT CLUSTER, (BROWN, 20-PIN PLUG) PIN 8
FACTORY ALARM DISARM	DISARMS WITH FACTORY REMOTE ONLY!!
ANTI-THEFT	CHRYSLERS MULTIPLEX IGNITION/TRANSPONDER SYSTEM, See NOTE #1

EXTRA INFORMATION

NOTE #1: This vehicle requires a Special INTERFACE BYPASS MODULE for REMOTE STARTING. Part # DB-ALL or XK09 to bypass this vehciles MULTIPLEX IGNITION/TRANSPONDER System. to order please go to the INTERFACE BYPASS MODULE Page on this website NOTE #2: THIS VEHICLE USES A SINGLE WIRE DOOR LOCKING SYSTEM THAT REQUIRES EXTRA PARTS. SEE DIAGRAM. NOTE #3: THE TIPM (TOTALLY INTEGRATED POWER MODULE) IS LOCATED IN THE ENGINE COMPARTMENT, ON THE DRIVERS FENDER.