PART | COLOR | LOCATION |
12 VOLT CONSTANT | RED (+) (X2) | @ IGNITION SWITCH HARNESS |
STARTER | LIGHT BLUE/RED (+) | @ IGNITION SWITCH HARNESS |
STARTER 2 | N/A | |
IGNITION 1 | PINK/LIGHT GREEN (+) | @ IGNITION SWITCH HARNESS |
IGNITION 2 | N/A | |
IGNITION 3 | N/A | |
ACCESSORY/HEATER BLOWER 1 | PINK/YELLOW (+) | @ IGNITION SWITCH HARNESS |
ACCESSORY/HEATER BLOWER 2 | PINK/YELLOW (+) | @ IGNITION SWITCH HARNESS |
KEYSENSE | N/A | |
PARKING LIGHTS ( - ) | PINK/RED (-) See NOTE #2 | @ HEADLIGHT Switch or BCM, 22-PIN Plug Pin 5, See NOTE #5 |
PARKING LIGHTS ( + ) | DO NOT USE!!! | |
POWER LOCK | TAN/DARK BLUE (1-Wire Door Lock System) See NOTE #3 | @ BACK of FUSEBOX, TOP LEFT Plug, Pin 14 |
POWER UNLOCK | Same wire, See DIAGRAM | See DIAGRAMS |
DOOR TRIGGER | See NOTE #4 | @ BCM, See NOTE #5 |
DOMELIGHT SUPERVISION | BLACK/WHITE (-) or YELLOW/LIGHT BLUE (-) Requires Part #775 Relay | @ BACK of FUSEBOX, TOP LEFT Plug, Pin 30 |
TRUNK RELEASE | LIGHT GREEN/WHITE (-) | @ BCM, 26-PIN PLUG, PIN 17, See NOTE #5 |
SLIDING POWER DOOR | N/A | |
HORN | DARK GREEN/PURPLE (-) | @ HORN SWITCH |
TACH | Any wire NOT RED/ORANGE or PINK/GRAY, (AC) | @ ANY FUEL-INJECTOR or IGNITION COIL |
WAIT TO START LIGHT | N/A | |
BRAKE | WHITE/TAN (+) | @ SWITCH ABOVE BRAKE PEDAL |
FACTORY ALARM DISARM | DISARMS with FACTORY REMOTE ONLY!!! | |
ANTI-THEFT | TRANSPONDER ANTI-THEFT SYSTEM, See NOTE #1 | TRANSPONDER @ IGNITION SWITCH TUMBLER |
EXTRA INFORMATION |
NOTE #1; This vehicle requires the 791 BYPASS MODULE for REMOTE STARTING, an Extra Ignition key is also required and will need to be placed inside the 791 for Operation. Part # DB-ALL or Part # XK09, either will bypass the Anti-Theft Without the extra key need and will also do keyless entry without the resistors. to order please go to the SECURITY BYPASS MODULE Page on this website. NOTE #2: the PARKING LIGHTS require a (-)Negative thru a 910 Ohm Resistor and an extra Relay part #775, to connect, See DIAGRAM NOTE #3: to LOCK requires a (-)Negative thru a 1400 Ohm Resistor and UNLOCK requires a (-)Negative thru a 426 Ohm Resistor, some units will also require 2 extra relays part #775, to connect, See DIAGRAM NOTE #4: the DRIVERS DOOR is a TAN (-) in the GRAY 26-PIN plug, pin 4, the PASSENGER DOOR is a TAN/RED (-) in the GRAY 26-PIN plug, pin 5, the DRIVERS REAR DOOR is a TAN/ORANGE (-) in the GRAY 22-PIN plug, pin 3, the PASSENGER REAR DOOR (-) is a TAN/YELLOW (-) is a TAN/YELLOW (-) in the GRAY 26-PIN plug, pin 22. When connecting to an ALARM SYSTEM, use all 4 DOOR TRIGGER wires and DIODE ISOLATE, to connect, See DIAGRAM NOTE #5; THE BCM (Body Control Module) IS ATTACHED TO THE LEFT OF THE FUSE BOX. |