Jeep Compass 2007-2010 Printer Friendly Wiring Chart

Jeep Compass 2007-2010

PART	COLOR	LOCATION
12 VOLT CONSTANT	RED (+)	@ BATTERY or TIPM, NOTE #3
STARTER	SEE NOTE #1
STARTER 2	SEE NOTE #1
IGNITION 1	PINK/WHITE (+)	@ IGNITION SWITCH (BLACK, 5-PIN PLUG) PIN 3
IGNITION 2	N/A
IGNITION 3	N/A
ACCESSORY/HEATER BLOWER 1	SEE NOTE #1
ACCESSORY/HEATER BLOWER 2	N/A
KEYSENSE	N/A
PARKING LIGHTS ( - )	N/A
PARKING LIGHTS ( + )	WHITE/PURPLE (+)	in DRIVERS KICK PANEL, Harness to Rear of Vehicle
POWER LOCK	LIGHT GREEN/DARK GREEN (-) thru a 330 Ohm Resistor, SEE NOTE #2	in DRIVERS KICK PANEL or INSTRUMENT CLUSTER, (BROWN 20-PIN PLUG) PIN 18, SEE DIAGRAM
POWER UNLOCK	USE LOCK WIRE, (-) thru a 100 Ohm Resistor	SEE DIAGRAM
DOOR TRIGGER	PURPLE/DARK BLUE (-)	IN DRIVERS KICK PANEL or INSTRUMENT CLUSTER, (BROWN, 20-PIN PLUG) PIN 3
DOMELIGHT SUPERVISION	YELLOW/WHITE (+)	@ DRIVERS A PILLAR or INSTRUMENT CLUSTER (BROWN, 20-PIN PLUG) PIN 4
TRUNK RELEASE	N/A
SLIDING POWER DOOR	N/A
HORN	DARK GREEN/PURPLE (-)	@ HORN SWITCH or INSTRUMENT CLUSTER (BLACK, 20-PIN PLUG) PIN 10
TACH	Any wire NOT DARK BLUE/LIGHT GREEN (AC)	@ Any FUEL-INJECTOR
WAIT TO START LIGHT	N/A
BRAKE	DARK GREEN/WHITE (+)	@ BRAKE SWITCH or INSTRUMENT CLUSTER (BROWN, 20-PIN PLUG) PIN 8
FACTORY ALARM DISARM	DISARMS WITH FACTORY REMOTE ONLY!!	N/A
ANTI-THEFT	CHRYSLER'S MULTIPLEX IGNITION/TRANSPONDER SYSTEM, See NOTE #1

EXTRA INFORMATION

NOTE #1: This vehicle requires a speciall INFERFACE BYPASS MODULE for REMOTE STARTING PART # DB-ALL or XK09 BYPASS MODULE, to order either module go to the INTERFACE BYPASS MODULE Page on this website. NOTE #2: THIS VEHICLES DOORLOCKS ARE A SINGLE WIRE SYSTEM REQUIRING A GROUND THRU A 100 OHM RESISTOR FOR UNLOCK AND A 330 OHM RESISTOR FOR LOCK. IF YOU HAVE THE CHALL OR THE CHDL7-PK2 MODULE, THIS MODULE WILL ALSO DO THE DOORLOCKS WITHOUT USING RESISTORS. NOTE #3: THE TIPM (TOTALLY INTEGRATED POWER MODULE) IS LOCATED IN THE ENGINE COMPARTMENT, ON THE DRIVERS FENDER.