Isuzu  I-370 2007-2008
 PART   COLOR  LOCATION
 12 VOLT CONSTANT   Connect DIRECTLY to BATTERY!!  
 STARTER  PURPLE (-), (NOT for REMOTE STARTING!!), NOTE #1  @ STARTER or UNDERHOOD FUSE BOX, (BLACK PLUG), PIN E2
 STARTER 2  WHITE/BLUE to WHITE (MUX), NOTE #1  @ IGNITION SWITCH, (PIN 4) or BCM, (GRAY PLUG), PIN A14, NOTE #2
 IGNITION 1  WHITE/GREEN to DK. BLUE (+), NOTE #1  @ IGNITION SWITCH, (PIN 3) or BCM, (GRAY PLUG), PIN B8, NOTE #2
 IGNITION 2  N/A  
 IGNITION 3  N/A  
 ACCESSORY/HEATER BLOWER 1  WHITE/RED to BROWN (+), NOTE #1  @ IGNITION SWITCH, (PIN 1) or BCM, (GRAY PLUG), PIN B7 NOTE #2
 ACCESSORY/HEATER BLOWER 2  N/A  
 KEYSENSE  N/A  
 PARKING LIGHTS ( - )  BROWN/WHITE (-)  @ HEADLIGHT SWITCH or BCM, (GRAY PLUG), PIN A7, NOTE #2
 PARKING LIGHTS ( + )  BROWN (+)  @ BCM, (BLACK PLUG), PIN A48, NOTE #2
 POWER LOCK  LT. BLUE (-), TYPE B  in EITHER KICK PANEL, or BCM, (BLACK PLUG), PIN A11, NOTE #2
 POWER UNLOCK  DK. BLUE (-), TYPE B, NOTE #3  in EITHER KICK PANEL, at DOOR HARNESS
 DOOR TRIGGER  GRAY/BLACK (-)  @ BCM, (BLACK PLUG), PIN A32, NOTE #2
 DOMELIGHT SUPERVISION  WHITE (-)  @ BCM, (BLACK PLUG), PIN A46, NOTE #2
 TRUNK RELEASE  N/A  
 SLIDING POWER DOOR  N/A  
 HORN  GREEN to BLACK (-)  @ HORN SWITCH or BCM, (GRAY PLUG), PIN A25, NOTE #2
 TACH  Any wire NOT PINK or BLACK, (AC)  @ Any IGNITION COIL or FUEL-INJECTOR
 WAIT TO START LIGHT  N/A  
 BRAKE  LT. BLUE (+)  @ BRAKE PEDAL SWITCH
 FACTORY ALARM DISARM   DISARMS with FACTORY REMOTE ONLY!!  
 ANTI-THEFT  GM'S (ION TYPE) PASSLOCK 2 ANTI-THEFT SYSTEM, Requires Bypass Module, See NOTE #1  @ IGNITION SWITCH HARNESS
 EXTRA INFORMATION
 NOTE #1: REQUIES SPECIAL BYPASS MODULE for REMOTE STARTING: Use a PLXR, PLJX, or an XK06 with PLXR 3.00 firmware. If you use a CANMAX 400 with 400.GM5 0.13 firmware, this will, in addition to remote start, also operate door locks and factory alarm. NOTE #2: the BCM (Body Control Module) is located in the PASSENGER KICK PANEL. NOTE #3: to UNLOCK just the DRIVERS DOOR, use the WHITE (-) at the BCM, (BLACK PUG), PIN A12.