Isuzu  Hombre 1998-2002
 PART   COLOR  LOCATION
 12 VOLT CONSTANT   RED (+)   IGNITION SWITCH HARNESS
 STARTER  YELLOW(+)  IGNITION SWITCH HARNESS
 STARTER 2  N/A  
 IGNITION 1  PINK(+)  IGNITION SWITCH HARNESS
 IGNITION 2  WHITE (+) See NOTE *4  IGNITION SWITCH HARNESS
 IGNITION 3  N/A  
 ACCESSORY/HEATER BLOWER 1  ORANGE (+)  IGNITION SWITCH HARNESS
 ACCESSORY/HEATER BLOWER 2  N/A  
 KEYSENSE  N/A  
 PARKING LIGHTS ( - )  WHITE (-)  @ BCM, IN LIGHT BLUE PLUG, See NOTE *1
 PARKING LIGHTS ( + )  BROWN (+)  @ BCM, IN LIGHT BLUE PLUG, See NOTE *1
 POWER LOCK  LIGHT BLUE (TYPE A)  @ BCM, IN BROWN PLUG, See NOTE *1
 POWER UNLOCK  WHITE (TYPE A)  @ BCM, IN BROWN PLUG, See NOTE *1
 DOOR TRIGGER  See NOTE *2  @ BCM, See NOTE *1
 DOMELIGHT SUPERVISION  TAN (-)  @ BCM, See NOTE *1
 TRUNK RELEASE  BLACK (-)  @ BCM, IN PURPLE PLUG, See NOTE *1
 SLIDING POWER DOOR  N/A  
 HORN  BLACK (-)  @ BCM, IN PURPLE PLUG, See NOTE *1
 TACH  WHITE  @ PCM, See NOTE *3
 WAIT TO START LIGHT  N/A  
 BRAKE  WHITE (+)  @ SWITCH ABOVE BRAKE PEDAL
 FACTORY ALARM DISARM   LIGHT GREEN (-)  @ BCM, IN PURPLE PLUG, See NOTE *1
 ANTI-THEFT  YELLOW (+), ORANGE/BLACK (-) and RED/WHITE (Not used)  GM's PASSLOCK 2 System, these wires exit the Ignition Switch Tumbler together and are in the Main Ignition Switch Harness in the Column.
 EXTRA INFORMATION
 NOTE *1 THE BCM (BODY CONTROL MODULE) IS LOCATED TO THE RIGHT OF THE GAS PEDAL BELOW THE RADIO.THE PLUGS ON THE BCM FACE TOWARDS THE DRIVERS SIDE. NOTE *2 USE TAN (-) FOR THE DRIVERS DOOR LOCATED IN PIN B4 OF THE PURPLE PLUG.USE ORANGE (-) FOR THE PASSENGER DOOR LOCATED IN PIN B2 OF THE PURPLE PLUG,MUST DIODE ISOLATE THE WIRES. NOTE *3 THE PCM (POWERTRAIN CONTROL MODULE) IS LOCATED ON THE PASSENGER FENDER.ON THE 2.2 LITER THE WIRE IS IN A BLACK 80 PIN PLUG PIN 10,AND ON THE 4.3 LITER THE WIRE IS IN A RED 32 PIN PLUG PIN 20. NOTE *4 IMPORTANT!!!!! THIS WIRE MUST BE CONNECTED AS IGNITION #2 FOR REMOTE STARTING!!!!!