Infiniti  Qx56 2008-2010
 PART   COLOR  LOCATION
 12 VOLT CONSTANT   GREEN (+) 40 AMP   @ IGNITION SWITCH, (WHITE, 6-PIN PLUG), PIN 3
 STARTER  BROWN (+)  @ IGNITION SWITCH, (WHITE, 6-PIN PLUG), PIN 2
 STARTER 2  LT. GREEN (+)  @ IGNITION SWITCH, (WHITE, 6-PIN PLUG), PIN 6
 IGNITION 1  BLACK/RED (+)  @ IGNITION SWITCH, (WHITE, 6-PIN PLUG), PIN 1
 IGNITION 2  N/A  
 IGNITION 3  N/A  
 ACCESSORY/HEATER BLOWER 1  RED (+)  @ IGNITION SWITCH, (WHITE, 6-PIN PLUG), PIN 4
 ACCESSORY/HEATER BLOWER 2  PURPLE (+)  @ IGNITION SWITCH, (WHITE, 6-PIN PLUG), PIN 5
 KEYSENSE  N/A  
 PARKING LIGHTS ( - )  N/A  
 PARKING LIGHTS ( + )  RED/BLUE (+)  in EITHER KICK PANEL, Harness to REAR of Vehicle
 POWER LOCK  BLUE (-), TYPE B, NOTE #3  @ POWER WINDOW Main Switch, (WHITE, 16-PIN PLUG), PIN 4
 POWER UNLOCK  RED (-), TYPE B, Requires Double Pulse, NOTE #4  @ POWER WINDOW Main Switch, (WHITE, 16-PIN PLUG), PIN 6
 DOOR TRIGGER  LT. BLUE (-)  in DRIVERS KICK PANEL or BCM, (BLACK, 15-PIN PLUG), PIN 7, NOTE #2
 DOMELIGHT SUPERVISION  BLUE (-)  in PASSENGER A Pillar or BCM, (BLACK, 15-PIN PLUG), PIN 8, NOTE #2
 TRUNK RELEASE  YELLOW/BROWN (-) (Hatch Glass), NOTE #5  in PASSENGER KICK PANEL or BCM, (BLACK, 40-PIN PLUG), PIN 30, NOTE #2
 SLIDING POWER DOOR  N/A  
 HORN  RED/WHITE (-)  @ HORN Switch, (GRAY, 8-PIN PLUG), PIN 2
 TACH  Any wire NOT WHITE (AC)  @ Any FUEL-INJECTOR
 WAIT TO START LIGHT  N/A  
 BRAKE  RED/GREEN to RED/BLACK (+)  @ BRAKE PEDAL SWITCH or in EITHER KICK PANEL, Harness to REAR of Vehicle
 FACTORY ALARM DISARM   Use UNLOCK wire  
 ANTI-THEFT  INFINITI'S TRANSPONDER ANTI-THEFT SYSTEM, Requires Bypass Module, See NOTE #1  
 EXTRA INFORMATION
 NOTE #1: NISSAN'S TRANSPONDER ANTI-THEFT SYSTEM, Requires Bypass Module, Part # 791 or XK02 (For REMOTE START ONLY) Part # DLPK-CANBUS MULTI (for REMOTE START and DOOR LOCKS) NOTE #2: the BCM (Body Control Module) is located Under the DRIVERS SIDE DASH, to the RIGHT of the Steering Column. NOTE #3: TEST this wire while Turning the KEY in the Drivers Door. This wire will also ARM the FACTORY ALARM. NOTE #4: TEST this wire while Turning the KEY in the Drivers Door. This wire will also DISARM the FACTORY ALARM. NOTE #5: TEST this wire while opening the HATCH GLASS with the Handle on the REAR of the Vehicle. On vehicles with POWER LIFTGATE, the Open/Close wire is a BLUE/WHITE (-) located in the DRIVERS KICK PANEL, Harness to REAR of Vehicle or at the POWER LIFTGATE Switch, (GRAY, 6-PIN PLUG), PIN 1.