Infiniti M45 2006-2010 Printer Friendly Wiring Chart

Infiniti M45 2006-2010

PART	COLOR	LOCATION
12 VOLT CONSTANT	RED (+)	@ CIRCUIT BREAKER, (WHITE, 2-PIN PLUG), PIN 1, NOTE #5
STARTER	RED (+)	@ PDU, (WHITE, 6-PIN PLUG), PIN 1, NOTE #6
STARTER 2	BROWN/WHITE (-) (PUSH-BUTTON START)	@ PUSH-BUTTON IGNITION Switch or IKU, (WHITE, 40-PIN PLUG), PIN 39, NOTE #7
IGNITION 1	BROWN (+)	@ PDU, (WHITE, 6-PIN PLUG), PIN 6, NOTE #6
IGNITION 2	N/A
IGNITION 3	N/A
ACCESSORY/HEATER BLOWER 1	WHITE (+)	@ PDU, (WHITE, 6-PIN PLUG), PIN 4, NOTE #6
ACCESSORY/HEATER BLOWER 2	N/A
KEYSENSE	N/A
PARKING LIGHTS ( - )	N/A
PARKING LIGHTS ( + )	RED/BLUE (+)	in DRIVERS KICK PANEL, Harness to REAR of Vehicle
POWER LOCK	BROWN (TYPE B), NOTE #3	@ POWER WINDOW Main Switch, (WHITE, 16-PIN PLUG), PIN 4
POWER UNLOCK	PURPLE/RED (TYPE B), Requires Double Pulse, NOTE #4	@ POWER WINDOW Main Switch, (WHITE, 16-PIN PLUG), PIN 6
DOOR TRIGGER	PURPLE (-)	in DRIVERS KICK PANEL or BCM, (BLACK, 15-PIN PLUG), PIN 7, NOTE #2
DOMELIGHT SUPERVISION	BROWN (-)	@ BCM, (BLACK, 15-PIN PLUG), PIN 8, NOTE #2
TRUNK RELEASE	ORANGE (-)	@ RELEASE SWITCH or BCM, (WHITE, 40-PIN PLUG), PIN 30, NOTE #2
SLIDING POWER DOOR	N/A
HORN	BROWN/WHITE (-)	@ HORN SWITCH, (GRAY, 8-PIN PLUG), PIN 8
TACH	Any wire NOT WHITE or WHITE/BLUE (AC)	@ Any FUEL -INJECTOR
WAIT TO START LIGHT	N/A
BRAKE	PINK/BLUE (+)	@ BRAKE PEDAL Switch or in DRIVERS KICK PANEL, Harness to REAR of Vehicle.
FACTORY ALARM DISARM	Use UNLOCK wire
ANTI-THEFT	INFINITI'S TRANSPONDER ANTI-THEFT SYSTEM, Requires Bypass Module, See NOTE #1

EXTRA INFORMATION

NOTE #1: This vehicle is equipped with INFINITI'S TRANSPONDER ANTI-THEFT System that requires a Bypass Module for Remote Starting: Part# 791 Bypass Module (Key Required) requires an Extra Ignition Key placed inside module for Operation FOR REMOTE STARTING ONLY!!. Part # DB-ALL or XK09 Interface Bypass Module (No Key Required) Either bypass is for Remote Starting and does the door locks (keyless entry) To order go to the INTERFACE BYPASS MODULE Page on this website. NOTE #2: the BCM (Body Control Module) is located behind the GLOVE BOX. NOTE #3: TEST this wire while Turning the KEY in the Drivers Door. This wire will also ARM the FACTORY ALARM. NOTE #4: TEST this wire while Turning the KEY in the Drivers Door. This wire will also DISARM the FACTORY ALARM. NOTE #5: the CIRCUIT BREAKER is located under the DRIVERS DASH, behind the DATA LINK Connector. NOTE #6: the PDU, (Power Distribution) is located behind the INSTRUMENT CLUSTER. NOTE #7: the IKU, (Intelligent Key Unit) is located in the DRIVERS KICK PANEL, below the FUSE BOX.