Infiniti Fx35 2006-2008 Printer Friendly Wiring Chart

Infiniti Fx35 2006-2008

PART	COLOR	LOCATION
12 VOLT CONSTANT	BLUE/RED to RED (+)	@ IGNITION SWITCH, (WHITE, 6-PIN PLUG), PIN 1
STARTER	BLUE (+)	@ IGNITION SWITCH, (WHITE, 6-PIN PLUG), PIN 5
STARTER 2	PINK (+)	@ IGNITION SWITCH, (WHITE, 6-PIN PLUG), PIN 6
IGNITION 1	BLACK (+)	@ IGNITION SWITCH, (WHITE, 6-PIN PLUG), PIN 3
IGNITION 2	N/A
IGNITION 3	N/A
ACCESSORY/HEATER BLOWER 1	WHITE (+)	@ IGNITION SWITCH, (WHITE, 6-PIN PLUG), PIN 2
ACCESSORY/HEATER BLOWER 2	N/A
KEYSENSE	N/A
PARKING LIGHTS ( - )	N/A
PARKING LIGHTS ( + )	RED to WHITE (+)	in DRIVERS KICK PANEL, (WHITE, 12-PIN PLUG), PIN 2
POWER LOCK	PINK (TYPE B), NOTE #3	@ POWER WINDOW Main Switch, (WHITE, 16-PIN PLUG), PIN 4
POWER UNLOCK	ORANGE (TYPE B), Requires Double Pulse, NOTE #4	@ POWER WINDOW Main Switch, (WHITE, 16-PIN PLUG), PIN 6
DOOR TRIGGER	WHITE (-)	@ BCM, (BLACK, 15-PIN PUG), PIN 7
DOMELIGHT SUPERVISION	PURPLE/WHITE (-)	@ BCM, (BLACK, 15-PIN PUG), PIN 8
TRUNK RELEASE	YELLOW (-), NOTE #5	@ BACK DOOR OPENER Switch on Hatch
SLIDING POWER DOOR	N/A
HORN	GREEN/BLACK to LT. BLUE (-)	@ HORN Switch, in Steering Column
TACH	Any wire NOT RED (AC)	@ Any FUEL-INJECTOR
WAIT TO START LIGHT	N/A
BRAKE	PINK (+)	@ BRAKE PEDAL Switch or in DRIVERS KICK PANEL, Harness to REAR of Vehicle
FACTORY ALARM DISARM	Use UNLOCK wire
ANTI-THEFT	INFINITI'S TRANSPONDER ANTI-THEFT SYSTEM, Requires Bypass Module, See NOTE #1	TRANSPONDER @ IGNITION SWITCH TUMBLER

EXTRA INFORMATION

NOTE #1 This vehicle is Equipped with a TRANPONDER ANTI-THEFT System that will requires a Bypass Module for REMOTE STARTING: Part # 791 Bypass Module will work IF you have another IGNITION key that you can give up, this key will need to be placed inside the 791 Bypass Module and be left there for Remote Starting. Part # DB-ALL or XK09 is a Keyless Bypass Module used for Remote Starting that DOES NOT require a Key to be left inside the bypass module. To order go to the INTERFACE BYPASS MODULE PAGE on this website. NOTE #2: the BCM (Body Control Module) is located in the DRIVERS KICK PANEL. NOTE #3: TEST this wire while Turning the KEY in the Drivers Door. This wire will also ARM the FACTORY ALARM. NOTE #4: TEST this wire while Turning the KEY in the Drivers Door. This wire will also DISARM the FACTORY ALARM. NOTE #5: TEST this wire while opening the HATCH with the Handle on the REAR of the Vehicle. On vehicles with INTELLIGENT KEY, it is a LT. GREEN (-) located in the DRIVERS KICK PANEL, Harness to REAR of Vehicle.