Hyundai  Genesis Coupe 2010-2011
 PART   COLOR  LOCATION
 12 VOLT CONSTANT   RED (+), NOTE #2   @ IGNITION SWITCH, (WHITE, 6-PIN PLUG), PIN 2
 STARTER  PINK (+), NOTE #3  @ IGNITION SWITCH, (WHITE, 6-PIN PLUG), PIN 1
 STARTER 2  BLUE(+)(SW1), PIN(+)(SW2) (SMART KEY)  @ START/STOP BUTTON SWITCH, (BLACK, 10-PIN PLUG), PINS 1 and 7
 IGNITION 1  BLUE (+), NOTE #4  @ IGNITION SWITCH, (WHITE, 6-PIN PLUG), PIN 6
 IGNITION 2  N/A  
 IGNITION 3  N/A  
 ACCESSORY/HEATER BLOWER 1  ORANGE (+), NOTE #5  @ IGNITION SWITCH, (WHITE, 6-PIN PLUG), PIN 3
 ACCESSORY/HEATER BLOWER 2  YELLOW (+), NOTE #6  @ IGNITION SWITCH, (WHITE, 6-PIN PLUG), PIN 4
 KEYSENSE  N/A  
 PARKING LIGHTS ( - )  WHITE (-)  @ HEADLIGHT SWITCH, (WHITE, 13-PIN PLUG), PIN 1
 PARKING LIGHTS ( + )  BLUE(+)(Left) and BLUE or GRAY(+)(Right) use both  @ DASH FUSE BOX, (BLUE, 14-PIN PLUG(G), PINS 6 and 3
 POWER LOCK  PINK (TYPE B)  in DRIVERS KICK PANEL, (BLUE, 39-PIN PLUG), PIN 36
 POWER UNLOCK  ORANGE (TYPE B)  in DRIVERS KICK PANEL, (BLUE, 39-PIN PLUG), PIN 23
 DOOR TRIGGER  ORANGE (-)  in DRIVERS KICK PANEL, (BLUE, 39-PIN PLUG), PIN 34
 DOMELIGHT SUPERVISION  GREEN (-)  in DRIVERS A Pillar, (WHITE, 12-PIN PLUG), PIN 3
 TRUNK RELEASE  YELLOW (-)  in DRIVERS KICK PANEL, (BLUE, 39-PIN PLUG), PIN 1
 SLIDING POWER DOOR  N/A  
 HORN  GREEN/ORANGE (-)  @ HORN SWITCH or in DRIVERS KICK PANEL, (BLUE, 42-PIN PLUG), PIN 11
 TACH  NOTE #7  @ Any FUEL-INJECTOR
 WAIT TO START LIGHT  N/A  
 BRAKE  RED/ORANGE (+)  in DRIVERS KICK PANEL, (WHITE, 22-PIN PLUG), PIN 2
 FACTORY ALARM DISARM   GREEN and BROWN/ORANGE (+), Requires Double Pulse, NOTE #8  in DRIVERS KICK PANEL, (BLUE, 39-PIN PLUG), PINS 27 and 29
 ANTI-THEFT  HYUNDAI'S TRANSPONDER ANTI-THEFT SYSTEM, Requires Bypass Module, See NOTE #1  @ IGNITION SWITCH TUMBLER
 EXTRA INFORMATION
 NOTE #1: This vehicle May Be Equipped with HYUNDAI'S TRANSPONDER ANTI-THEFT SYSTEM, check the OWNERS MANUAL for this vehcile or contact your HYUNDAI Dealer to see if the vehicle has a Special programmed Ignition Key, if it does, then for REMOTE STARTING you will need the 791 BYPASS Module and an Extra Ignition key. To Order the 791 go to the SECURITY BYPASS MODULE Page on this website. NOTE #2: on Vehicles with SMART KEY, use RED (+) 30 AMP, at the DRIVERS DASH FUSE BOX, (WHITE, 20-PIN PLUG(H), PIN 14. NOTE #3: on Vehicles with SMART KEY, use WHITE(+), at the PDM, (BLACK, 10-PIN PLUG), PIN 6. the PDM, (Power distibution Module) is under the DRIVERS DASH and to the RIGHT of the STEERING COLUMN. NOTE #4: on Vehicles with SMART KEY, use BLUE/ORANGE (+), at the PDM, (BLACK, 10-PIN PLUG), PIN 7. the PDM, (Power distibution Module) is under the DRIVERS DASH and to the RIGHT of the STEERING COLUMN. NOTE #5: on Vehicles with SMART KEY, use GREEN (+), at the PDM, (BLACK, 10-PIN PLUG), PIN 8. the PDM, (Power distibution Module) is under the DRIVERS DASH and to the RIGHT of the STEERING COLUMN. NOTE #6: on Vehicles with SMART KEY, use ORANGE/BLACK (+), at the PDM, (BLACK, 10-PIN PLUG), PIN 9. the PDM, (Power distibution Module) is under the DRIVERS DASH and to the RIGHT of the STEERING COLUMN. NOTE #7: when using the TACH wire, on the V6 use any wire NOT ORANGE (AC) and on the 4 CYL use GREEN, PINK, BLUE or ORANGE, at any FUEL-INJECTOR. NOTE #8: TEST these wires while turning the KEY in the DRIVERS DOOR.