Vehicle
Wiring Details for your
2012- Buick Verano Wiring Diagram |
Printer Friendly
Version |
|
|
Listed below is the vehicle specific wiring diagram for your car alarm, remote starter or keyless entry installation into your 2012- Buick Verano . This information outlines the wires location, color and polarity to help you identify the proper connection spots in the vehicle. Please be sure to test all of your wires with a digital multimeter before making any connections. More information on using a multimeter and testing wires please see our Technical Support Area.
|
|
|
 |
| PART |
COLOR |
LOCATION |
| 12 VOLT
CONSTANT |
RED/BLUE (+) (100AMP) |
IN DRIVERS KICK PANEL, BLACK 102-PIN PLUG, PIN 90 |
| STARTER |
See NOTE #1 |
|
| STARTER
2 |
N/A |
|
| IGNITION
1 |
PURPLE/BLACK (+) |
@ Ignition Switch or BCM, (LT. GREEN 25-Pin Plug) Pin 6, See NOTE #2 |
| IGNITION
2 |
N/A |
|
| IGNITION
3 |
N/A |
|
| ACCESSORY/HEATER
BLOWER 1 |
PURPLE/YELLOW (+) |
@ Ignition Switch or BCM, (LT. GREEN 25-Pin Plug) Pin 5, See NOTE #2 |
| ACCESSORY/HEATER
BLOWER 2 |
N/A |
|
| KEYSENSE |
N/A |
|
| PARKING
LIGHTS ( - ) |
GREEN/GRAY (-) |
@ HEADLIGHT Switch or BCM, (WHITE 26-Pin Plug) Pin 22, See NOTE #2 |
| PARKING
LIGHTS ( + ) |
N/A |
|
| POWER LOCK |
BROWN/YELLOW, TYPE-B (-) |
IN DRIVERS KICK PANEL or BCM, PINK 27-PIN PLUG, PIN 14, See NOTE #2 |
| POWER UNLOCK |
BROWN/WHITE, TYPE-B (-) |
IN DRIVERS KICK PANEL or BCM, PINK 27-PIN PLUG, PIN 13, See NOTE # |
| DOOR TRIGGER |
GRAY (-) |
@ DRIVERS DOOR WINDOW MOTOR, BLACK 7-PIN PLUG, PIN 1 |
| DOMELIGHT
SUPERVISION |
GRAY (+) |
@ BCM, (GRAY 26-Pin Plug) Pin 1, See NOTE #2 |
| TRUNK RELEASE |
PURPLE/BLUE (-) |
@ BCM, (PINK 27-Pin Plug) Pin 15, See NOTE #2 |
| SLIDING
POWER DOOR |
N/A |
|
| HORN |
GREEN/WHITE to BROWN/WHITE (-) |
@ Horn Switch or BCM, (BROWN 26-Pin Plug) Pin 19, See NOTE #2 |
| TACH |
a BROWN, BLUE, GREEN or LT BLUE (AC) |
@ TOP of ENGINE, BLACK 12-Pin Plug, pins 1,2,3 or 4 |
| WAIT TO
START LIGHT |
N/A |
|
| BRAKE |
PURPLE/WHITE (+) |
@ BCM, (BLACK 26-Pin Plug) Pin 11, See NOTE #2 |
| FACTORY
ALARM DISARM |
N/A |
|
| ANTI-THEFT |
See NOTE #1 |
|
| EXTRA
INFORMATION |
| NOTE #1: This vehicle will Require a INTERFACE BYPASS MODULE, at this time the Bypass Module
is NOT available, please check with tech support to see when it will be available.
NOTE #2: The BCM, is located in the FRONT Passengerside of the Center Console.
|
|
|
|
|
|
