Vehicle
Wiring Details for your
2011-2012 Ford Explorer Wiring Diagram |
Printer Friendly
Version |
|
|
Listed below is the vehicle specific wiring diagram for your car alarm, remote starter or keyless entry installation into your 2011-2012 Ford Explorer . This information outlines the wires location, color and polarity to help you identify the proper connection spots in the vehicle. Please be sure to test all of your wires with a digital multimeter before making any connections. More information on using a multimeter and testing wires please see our Technical Support Area.
|
|
|
 |
| PART |
COLOR |
LOCATION |
| 12 VOLT
CONSTANT |
CONNECT TO BATTERY ONLY! |
@ BATTERY |
| STARTER |
BLUE/WHITE (+) (without INTELLIGENT ACCESS) |
@ IGNITION SWITCH, BLACK 7-PIN PLUG, PIN 7 |
| STARTER
2 |
BLUE/WHITE (+) (with INTELLIGENT ACCESS) |
@ START/STOP SWITCH, BLACK 6-PIN PLUG, PIN 1 |
| IGNITION
1 |
WHITE/ORANGE (+), SEE NOTE #2 |
@ IGNITION SWITCH, BLACK 7-PIN PLUG, PIN 1 |
| IGNITION
2 |
N/A |
|
| IGNITION
3 |
N/A |
|
| ACCESSORY/HEATER
BLOWER 1 |
PURPLE/GREEN (+) |
@ IGNITION SWITCH, BLACK 7-PIN PLUG, PIN 6 |
| ACCESSORY/HEATER
BLOWER 2 |
N/A |
|
| KEYSENSE |
N/A |
|
| PARKING
LIGHTS ( - ) |
N/A |
|
| PARKING
LIGHTS ( + ) |
YELLOW/BLUE (+) |
@ BCM, GRAY 10-PIN PLUG(E), PIN 6, SEE NOTE #3 |
| POWER LOCK |
BLUE/GREEN (TYPE B) |
IN DRIVERS KICK PANEL or BCM, BLACK 26-PIN PLUG(C), PIN 6, SEE NOTE #3 |
| POWER UNLOCK |
YELLOW/PURPLE, (TYPE B) |
IN DRIVERS KICK PANEL or BCM, BLACK 26-PIN PLUG(C), PIN 8, SEE NOTE #3 |
| DOOR TRIGGER |
GREEN/PURPLE (-) |
IN DRIVERS KICK PANEL or BCM, BLACK 26-PIN PLUG(C), PIN 9, SEE NOTE #3 |
| DOMELIGHT
SUPERVISION |
GRAY/PURPLE (+) |
@ BCM, GRAY 12-PIN PLUG(A), PIN 1, SEE NOTE #3 |
| TRUNK RELEASE |
BROWN (-) |
IN DRIVERS KICK PANEL or BCM, BLACK 26-PIN PLUG(C), PIN 23, SEE NOTE #3 |
| SLIDING
POWER DOOR |
N/A |
|
| HORN |
PURPLE/GREEN (-) |
@ HORN SWITCH or BCM, BLACK 52-PIN PLUG(B), PIN 33, SEE NOTE #3 |
| TACH |
GREEN/BLUE, GRAY/YELLOW, PURPLE/GRAY, YELLOW/ORANGE, BROWN or GREEN/WHITE (AC) |
@ ANY FUEL-INJECTOR, 2-PIN PLUG, PIN 1 |
| WAIT TO
START LIGHT |
N/A |
|
| BRAKE |
BLUE/ORANGE (+) |
@ TRAILER BRAKE PRE-WIRE HARNESS, GRAY 6-PIN PLUG, PIN 2, SEE NOTE #4 |
| FACTORY
ALARM DISARM |
DISARMS with FACTORY REMOTE ONLY!! |
|
| ANTI-THEFT |
EQUIPPED WITH FORDS TRANSPONDER ANTI-THEFT SYSTEM, REQUIRES 791 BYPASS MODULE, SEE NOTE #1 |
@ IGNITION SWITCH TUMBLER |
| EXTRA
INFORMATION |
| NOTE #1: This vehicle is EQUIPPED with FORDS TRANSPONDER ANTI-THEFT SYSTEM, and it will
REQUIRE the 791 BYPASS MODULE and an extra programmed IGNITION KEY to
REMOTE START, at this time there is no KEYLESS BYPASS OFFERED, to order the 791 go
to the SECURITY BYPASS Page on this website. If 2011 and shaft of key has "SA" stamped into
the metal this is Fords new 80bit key and will require a PKTK interface module.
NOTE #2: On vehicles with INTELLIGENT ACCESS, use the PURPLE/ORANGE (+) (for IGNITION
SENSE ONLY) located at the BCM, GRAY 10-PIN PLUG(E), PIN 10
NOTE #3: The BCM is located part of the DASH FUSE BOX, under the DRIVERS DASH.
NOTE #4; The TRAILER BRAKE PRE-WIRE HARNESS is located behind the HOOD RELEASE
|
|
|
|
|
|
