Vehicle
Wiring Details for your
2011-2012 Dodge Charger Wiring Diagram |
Printer Friendly
Version |
|
|
Listed below is the vehicle specific wiring diagram for your car alarm, remote starter or keyless entry installation into your 2011-2012 Dodge Charger . This information outlines the wires location, color and polarity to help you identify the proper connection spots in the vehicle. Please be sure to test all of your wires with a digital multimeter before making any connections. More information on using a multimeter and testing wires please see our Technical Support Area.
|
|
|
 |
| PART |
COLOR |
LOCATION |
| 12 VOLT
CONSTANT |
RED/YELLOW (+) |
@ BCM, LT.GRAY 4-PIN PLUG (C2), PIN 3, SEE NOTE #2 |
| STARTER |
LT.BLUE/TAN (+) |
@ BCM, BLACK 24-PIN PLUG (C1), PIN 19, SEE NOTE #2 |
| STARTER
2 |
PURPLE/LT.BLUE |
@ KEYLESS IGNITION NODE(START/STOP BUTTON), BLACK 6-PIN PLUG, PIN 3 |
| IGNITION
1 |
PINK/WHITE (+) |
@ BCM, BLACK 24-PIN PLUG (C1), PIN 19, SEE NOTE #2 |
| IGNITION
2 |
N/A |
|
| IGNITION
3 |
N/A |
|
| ACCESSORY/HEATER
BLOWER 1 |
N/A |
|
| ACCESSORY/HEATER
BLOWER 2 |
N/A |
|
| KEYSENSE |
N/A |
|
| PARKING
LIGHTS ( - ) |
WHITE/BROWN (-) THRU a 1130 Ohm Resistor, use Relay to isolate Switch |
@ BCM, LT.BLUE 24-PIN PLUG (C7), PIN 20, SEE NOTE #2 |
| PARKING
LIGHTS ( + ) |
SEE NOTE #3 |
@ BCM, SEE NOTE #2 |
| POWER LOCK |
PURLE/LT. GREEN (-) THRU a 330 Ohm Resistor will LOCK |
@ PASSENGER DOOR Module, BLACK 10-PIN PLUG, PIN 4 |
| POWER UNLOCK |
using same wire, a (-) THRU a 100 Ohm Resistor will UNLOCK |
|
| DOOR TRIGGER |
PURPLE (-) |
@ BCM, BLACK 48-PIN PLUG(C6) PIN 25, SEE NOTE #2 |
| DOMELIGHT
SUPERVISION |
YELLOW/PURPLE (+) |
@ BCM, BLUE 24-PIN PLUG(C7) PIN 14, SEE NOTE #2 |
| TRUNK RELEASE |
LT.GREEN (-) |
@ BCM, BLUE 24-PIN PLUG(C7) PIN 8, SEE NOTE #2 |
| SLIDING
POWER DOOR |
N/A |
|
| HORN |
DK. GREEN/WHITE (+) |
@ BCM, BLACK 24-PIN PLUG(C1), PIN 23, SEE NOTE #2 |
| TACH |
SEE NOTE #4 |
@ ANY FUEL-INJECTOR |
| WAIT TO
START LIGHT |
N/A |
|
| BRAKE |
DK. GREEN/WHITE (+) |
@ BCM, BLACK 24-PIN PLUG (C1), PIN 23, SEE NOTE #2 |
| FACTORY
ALARM DISARM |
N/A |
|
| ANTI-THEFT |
SEE NOTE #1 |
|
| EXTRA
INFORMATION |
| NOTE #1: this vehicle requires a SPECIAL INTERFACE BYPASS MODULE to REMOTE START and for
KEYLESS ENTRY part # DB-ALL to order go to the INTERFACE BYPASS MODULE Page
on this website.
NOTE #2: The BCM is located behind the GLOVEBOX.
NOTE #3: The LEFT FRONT Parkinglight wire is a WHITE/DK.GREEN (+) @ BCM, BLACK 24-PIN PLUG(C1) PIN 4, the RIGHT FRONT Parking light wire is a WHITE/LT.BLUE (+) @ BCM, WHITE 24-PIN PLUG(C4) PIN 3, the LEFT REAR Parking light wire is a WHITE/GRAY (+) @ BCM, BLACK 48-PIN PLUG(C6) PIN 32 and the RIGHT REAR Parking light wire is a WHITE/PURPLE (+) @ BCM, BLACK 48-PIN PLUG(C5) PIN 4, when connecting use a relay for each to isolate.
NOTE #4: The TACH wire on the V-6 is Any wire NOT BROWN/WHITE (AC) and on the V-8 it is Any wire NOT BROWN (AC)
|
|
|
|
|
|
