Vehicle
Wiring Details for your
2011-2012 Chrysler 300/300C Wiring Diagram |
Printer Friendly
Version |
|
|
Listed below is the vehicle specific wiring diagram for your car alarm, remote starter or keyless entry installation into your 2011-2012 Chrysler 300/300C . This information outlines the wires location, color and polarity to help you identify the proper connection spots in the vehicle. Please be sure to test all of your wires with a digital multimeter before making any connections. More information on using a multimeter and testing wires please see our Technical Support Area.
|
|
|
 |
| PART |
COLOR |
LOCATION |
| 12 VOLT
CONSTANT |
RED/YELLOW (+) (40AMP) |
@ BCM, LT. GRAY 4-PIN PLUG (C2), PIN 3, SEE NOTE #2 |
| STARTER |
See NOTE #4 |
|
| STARTER
2 |
N/A |
|
| IGNITION
1 |
PINK/WHITE (+) |
@ BCM, BLACK 48-PIN PLUG (C5), PIN 27, SEE NOTE #2 |
| IGNITION
2 |
N/A |
|
| IGNITION
3 |
N/A |
|
| ACCESSORY/HEATER
BLOWER 1 |
N/A |
|
| ACCESSORY/HEATER
BLOWER 2 |
N/A |
|
| KEYSENSE |
N/A |
|
| PARKING
LIGHTS ( - ) |
WHITE/BROWN (-) (use Relay to Isolate) (-) thru a 1130Ohm Resistor |
@ BCM, BLUE 24-PIN PLUG(C7), PIN 20, SEE NOTE #2 |
| PARKING
LIGHTS ( + ) |
N/A |
|
| POWER LOCK |
PURPLE/LT.GREEN (-) THRU A 330 Ohm Resistor will LOCK (Passenger Door lock switch) |
@ PASSENGER DOOR MODULE, BLACK 10-PIN PLUG, PIN 4 |
| POWER UNLOCK |
Use same wire, (-) thru a 100 Ohm Resistor Unlocks |
|
| DOOR TRIGGER |
PURPLE (-) |
@ BCM, BLACK 48-PIN PLUG(C6), PIN 26, SEE NOTE #2 |
| DOMELIGHT
SUPERVISION |
YELLOW/PURPLE (+) |
@ BCM, BLUE 24-PIN PLUG(C7), PIN 14, SEE NOTE #2 |
| TRUNK RELEASE |
LT.GREEN (-) |
@ BCM, BLUE 24-PIN PLUG(C7), PIN 8, SEE NOTE #2 |
| SLIDING
POWER DOOR |
N/A |
|
| HORN |
DK.GREEN/WHITE (-) |
@ BCM, BLACK 24-PIN PLUG(C1), PIN 23, SEE NOTE #2 |
| TACH |
SEE NOTE #3 |
@ ANY FUEL-INJECTOR |
| WAIT TO
START LIGHT |
N/A |
|
| BRAKE |
LT. GREEN/WHITE (+) |
@ BCM, WHITE 24-PIN PLUG(C4), PIN 18, SEE NOTE #2 |
| FACTORY
ALARM DISARM |
N/A |
|
| ANTI-THEFT |
See NOTE #4 |
|
| EXTRA
INFORMATION |
| NOTE #1: There is no information at this time for a INTERFACE BYPASS MODULE!!!
NOTE #2: The BCM is located Behind the GLOVE BOX.
NOTE #3: Use any wire NOT BROWN/WHITE (AC) on the V6 and any wire NOT BROWN (AC)
on the V8.
NOTE #4: This vehicle requires a SPECIAL INTERFACE BYPASS MODULE for REMOTE STARTING
and KEYLESS ENTRY PART # DB-ALL to order please go the the INTERFACE BYPASS
MODULE page on this website.
|
|
|
|
|
|
