Vehicle
Wiring Details for your
2011- Ford Fiesta Wiring Diagram |
Printer Friendly
Version |
|
|
Listed below is the vehicle specific wiring diagram for your car alarm, remote starter or keyless entry installation into your 2011- Ford Fiesta . This information outlines the wires location, color and polarity to help you identify the proper connection spots in the vehicle. Please be sure to test all of your wires with a digital multimeter before making any connections. More information on using a multimeter and testing wires please see our Technical Support Area.
|
|
|
 |
| PART |
COLOR |
LOCATION |
| 12 VOLT
CONSTANT |
RED (+) |
@ IGNITION SWITCH, BLACK 7-PIN PLUG, PIN 4 |
| STARTER |
BLUE/WHITE (+) (without INTELLIGENT ACCESS) |
@ IGNITION SWITCH, BLACK 7-PIN PLUG, PIN 7 |
| STARTER
2 |
BROWN/PURPLE (-) (SS1), YELLOW/ORANGE (-)(SS2)(with INTELLIGENT ACCESS) |
@ START/STOP SWITCH or RFA Module, GREEN 23-PIN PLUG, PINS 22 and 23, SEE NOTE #2 |
| IGNITION
1 |
BROWN/YELLOW (+), SEE NOTE #3 |
@ IGNITION SWITCH, BLACK 7-PIN PLUG, PIN 1 |
| IGNITION
2 |
N/A |
|
| IGNITION
3 |
N/A |
|
| ACCESSORY/HEATER
BLOWER 1 |
PURPLE/GREEN (+), SEE NOTE #4 |
@ IGNITION SWITCH, BLACK 7-PIN PLUG, PIN 6 |
| ACCESSORY/HEATER
BLOWER 2 |
N/A |
|
| KEYSENSE |
N/A |
|
| PARKING
LIGHTS ( - ) |
YELLOW/BLUE (-) |
@ HEADLIGHT SWITCH or BCM, GREEN 24-PIN PLUG(E), PIN 9, SEE NOTE #5 |
| PARKING
LIGHTS ( + ) |
N/A |
|
| POWER LOCK |
BROWN/WHITE (TYPE B) |
@ DOOR LOCK SWITCH or BCM, WHITE 24-PIN PLUG(F), PIN 8, SEE NOTE #5 |
| POWER UNLOCK |
SAME AS LOCK WIRE See Note#6 |
|
| DOOR TRIGGER |
GREEN/PURPLE (-) |
IN DRIVERS KICK or BCM, GRAY 24-PIN PLUG(G), PIN 10, SEE NOTE #5 |
| DOMELIGHT
SUPERVISION |
YELLOW/GRAY (-) |
@ DRIVERS |
| TRUNK RELEASE |
GREEN/WHITE (-) |
IN DRIVERS KICK or BCM, GRAY 24-PIN PLUG(G), PIN 20, SEE NOTE #5 |
| SLIDING
POWER DOOR |
N/A |
|
| HORN |
BROWN (-) |
@ HORN SWITCH or BCM, GREEN 24-PIN PLUG(E), PIN 21, SEE NOTE #5 |
| TACH |
YELLOW/BLUE, BLUE/ORANGE, GREEN/PURPLE or BLUE (AC) |
@ ANY FUEL-INJECTOR, GRAY 2-PIN PLUG, PIN 2 |
| WAIT TO
START LIGHT |
NA |
|
| BRAKE |
BLUE/GRAY (+) |
@ BRAKE PEDAL SWITCH, GRAY 2-PIN PLUG, PIN 2 |
| FACTORY
ALARM DISARM |
PURPLE/BROWN (-) |
@ BCM, GRAY 24-PIN PLUG(G), PIN 19, SEE NOTE #5 |
| ANTI-THEFT |
FORDS TRANSPONDER ANTI-THEFT SYSTEM, SEE NOTE #1 |
@ IGNITION SWITCH TUMBLER |
| EXTRA
INFORMATION |
| NOTE #1: This vehicle is equipped with a Special Anti-theft key, to remote start you will need a
Bypass module 791,(use this module IF you have a extra ignition key to place inside
the 791 to remote start, if you do not have an extra key to use or wish not to have a
key placed inside this bypass module, we OFFER a KEYLESS INTERFACE BYPASS
MODULE that does not require a key to be placed inside the bypass module, this is
Part # DB-ALL, to order, go to the INTERFACE BYPASS MODULE PAGE on this website.
If shaft of key has "SA" stamped into metal this is Fords new 80bit key and will require a PKTK interface module.
NOTE #2: The RFA Module is located under the Passenger Seat.
NOTE #3: On vehicles with INTELLIGENT ACCESS this wire is ORANGE (+) at the RFA Module,
BLUE 23-PIN PLUG, PIN 18.
NOTE #4: On vehicles with INTELLIGENT ACCESS this wire is ORANGE (+) at the RFA Module, BLUE 23-PIN PLUG, PIN 8.
NOTE #5: The BCM is located behind the GLOVE BOX.
NOTE #6: Negative pulses on this wire will alternate between lock and unlock.
|
|
|
|
|
|
