Vehicle
Wiring Details for your
2010-2012 Ford Fusion Wiring Diagram |
Printer Friendly
Version |
|
|
Listed below is the vehicle specific wiring diagram for your car alarm, remote starter or keyless entry installation into your 2010-2012 Ford Fusion . This information outlines the wires location, color and polarity to help you identify the proper connection spots in the vehicle. Please be sure to test all of your wires with a digital multimeter before making any connections. More information on using a multimeter and testing wires please see our Technical Support Area.
|
|
|
 |
| PART |
COLOR |
LOCATION |
| 12 VOLT
CONSTANT |
RED (+) |
@ SJB, BLACK 1-PIN PLUG, PIN 1, SEE NOTE #2 |
| STARTER |
BLUE/WHITE (+) |
@ IGNITION SWITCH, BLACK 7-PIN PLUG, PIN 7 |
| STARTER
2 |
N/A |
|
| IGNITION
1 |
WHITE/ORANGE (+) |
@ IGNITION SWITCH, BLACK 7-PIN PLUG, PIN 1 |
| IGNITION
2 |
N/A |
|
| IGNITION
3 |
N/A |
|
| ACCESSORY/HEATER
BLOWER 1 |
PURPLE/GREEN (+) |
@ IGNITION SWITCH, BLACK 7-PIN PLUG, PIN 6 |
| ACCESSORY/HEATER
BLOWER 2 |
N/A |
|
| KEYSENSE |
N/A |
|
| PARKING
LIGHTS ( - ) |
N/A |
|
| PARKING
LIGHTS ( + ) |
PURPLE/WHITE (+) |
IN DRIVERS KICK PANEL or SJB, GRAY 13-PIN PLUG(E), PIN 6, SEE NOTE #2 |
| POWER LOCK |
BLUE/GREEN (TYPE B) |
IN DRIVERS KICK PANEL or SJB, GRAY 26-PIN PLUG(C), PIN 17, SEE NOTE #2 |
| POWER UNLOCK |
YELLOW/PURPLE (TYPE B) |
IN DRIVERS KICK PANEL or SJB, GRAY 26-PIN PLUG(C), PIN 4, SEE NOTE #2 |
| DOOR TRIGGER |
GREEN/PURPLE (-) |
@ SJB, GRAY 26-PIN PLUG(C), PIN 14, SEE NOTE #2 |
| DOMELIGHT
SUPERVISION |
GRAY/PURPLE (+) |
@ SJB, GRAY 14-PIN PLUG(A), PIN 9, SEE NOTE #2 |
| TRUNK RELEASE |
BROWN/YELLOW (-) |
@ TRUNK RELEASE SWITCH or SJB, GRAY 26-PIN PLUG(C), PIN 20, SEE NOTE #2 |
| SLIDING
POWER DOOR |
N/A |
|
| HORN |
BLUE/WHITE (-) |
@ HORN SWITCH or SJB, BLACK 52-PIN PLUG(b), PIN 41, SEE NOTE #2 |
| TACH |
Any wire NOT BLUE (AC) |
@ ANY FUEL-INJECTOR |
| WAIT TO
START LIGHT |
N/A |
|
| BRAKE |
PURPLE/WHITE (+) |
@ BRAKE PEDAL SWITCH or SJB, BLACK 52-PIN PLUG(B), PIN 40, SEE NOTE #2 |
| FACTORY
ALARM DISARM |
DISARMS WITH FACTORY REMOTE ONLY!! |
|
| ANTI-THEFT |
FORDS TRANSPONDER ANTI-THEFT SYSTEM, SEE NOTE #1 |
IGNITION SWITCH TUMBLER |
| EXTRA
INFORMATION |
| NOTE #1: This vehicle is equipped with a Special Anti-theft key, to remote start you will
need a Bypass module 791, use this module IF you have a extra ignition key to
place inside the 791 to remote start, if you do not have an extra key to use or wish
not to have a key placed inside this bypass module, we OFFER a KEYLESS INTERFACE
BYPASS MODULE that does not require a key to be placed inside the bypass module,
this is Part # PKALL or PKFM, either one will work, to order, go to the INTERFACE
BYPASS MODULE PAGE on this website. If the key is stamped "SA" into the metal shaft
this is an 80-bit key and requires the PKTX interface module.
NOTE #2; The SJB(SMART JUNCTION BOX)is located under the Drivers Dash
|
|
|
|
|
|
