Vehicle
Wiring Details for your
2010-2011 Hyundai Santa Fe Wiring Diagram |
Printer Friendly
Version |
|
|
Listed below is the vehicle specific wiring diagram for your car alarm, remote starter or keyless entry installation into your 2010-2011 Hyundai Santa Fe . This information outlines the wires location, color and polarity to help you identify the proper connection spots in the vehicle. Please be sure to test all of your wires with a digital multimeter before making any connections. More information on using a multimeter and testing wires please see our Technical Support Area.
|
|
|
 |
| PART |
COLOR |
LOCATION |
| 12 VOLT
CONSTANT |
RED (+) 40 AMP |
@ IGNITION SWITCH, (BLACK, 6-PIN PLUG), PIN 5 |
| STARTER |
GREEN (+) |
@ IGNITION SWITCH, (BLACK, 6-PIN PLUG), PIN 1 |
| STARTER
2 |
N/A |
|
| IGNITION
1 |
ORANGE (+) |
@ IGNITION SWITCH, (BLACK, 6-PIN PLUG), PIN 6 |
| IGNITION
2 |
N/A |
|
| IGNITION
3 |
N/A |
|
| ACCESSORY/HEATER
BLOWER 1 |
BLUE (+) |
@ IGNITION SWITCH, (BLACK, 6-PIN PLUG), PIN 3 |
| ACCESSORY/HEATER
BLOWER 2 |
YELLOW (+) |
@ IGNITION SWITCH, (BLACK, 6-PIN PLUG), PIN 4 |
| KEYSENSE |
YELLOW (+) |
@ IGNITION KEY SWITCH, WHITE 6-PIN PLUG, PIN 3 |
| PARKING
LIGHTS ( - ) |
BLUE/ORANGE (-) |
@ HEADLIGHT SWITCH, (WHITE, 18-PIN PLUG), PIN 14 |
| PARKING
LIGHTS ( + ) |
GREEN(+)(Left) and YELLOW(+)(Right) use both! |
@ DASH FUSE BOX, (GRAY, 18-PIN PLUG(D), PINS 3 and 4 |
| POWER LOCK |
BLUE/BLACK(TYPE B) |
in DRIVERS KICK PANEL, (BROWN, 24-PIN PLUG), PIN 18 |
| POWER UNLOCK |
GRAY/BLACK(TYPE B), NOTE # |
in DRIVERS KICK PANEL, (BROWN, 24-PIN PLUG), PIN 19 |
| DOOR TRIGGER |
ORANGE (-) |
in DRIVERS KICK PANEL, (BROWN, 24-PIN PLUG), PIN 12 |
| DOMELIGHT
SUPERVISION |
BROWN (-) |
@ DASH FUSE BOX, (RED, 16-PIN PLUG(B), PIN 1 |
| TRUNK RELEASE |
UNLOCKS with Doors |
|
| SLIDING
POWER DOOR |
N/A |
|
| HORN |
GRAY/BLACK (-) |
in DRIVERS KICK PANEL, (GREEN, 24-PIN PLUG), PIN 20 |
| TACH |
Any wire NOT ORANGE (AC) |
@ Any FUEL-INJECTOR |
| WAIT TO
START LIGHT |
N/A |
|
| BRAKE |
NOTE #4 |
@ BRAKE PEDAL SWITCH, (WHITE, 4-PIN PLUG), PIN 1 |
| FACTORY
ALARM DISARM |
PINK and GRAY (-), Requires Double Pulse, NOTE #3 |
in DRIVERS KICK PANEL, (BROWN, 24-PIN PLUG), PINS 6 and 4 |
| ANTI-THEFT |
HYUNDAI'S TRANSPONDER ANTI-THEFT SYSTEM, Requires Bypass Module, See NOTE #1 |
@ IGNITION SWITCH TUMBLER |
| EXTRA
INFORMATION |
| NOTE #1: This vehicle May Be Equipped with HYUNDAI'S TRANSPONDER ANTI-THEFT SYSTEM,
check the OWNERS MANUAL for this vehcile or contact your HYUNDAI Dealer to see if
the vehicle has a Special programmed Ignition Key, if it does, then for REMOTE
STARTING you will need the 791 BYPASS Module and an Extra Ignition key.
To Order the 791 go to the SECURITY BYPASS MODULE Page on this website.
NOTE #2: the BCM, (Body Control Module) is located under the DRIVERS DASH, behind the
FUSE BOX.
NOTE #3: TEST these wires while TURNING the KEY in the DRIVERS DOOR.
NOTE #4: for the BRAKE wire, use the GREEN/BLACK(+) on the 2.4L Engine and on the
3.5L Engine use the GRAY (+)
NOTE #5: to UNLOCK just the DRIVERS DOOR, use the YELLOW/BLACK (-), at the BCM, ( WHITE,
22-PIN PLUG), PIN 13. NOTE #2
|
|
|
|
|
|
