Vehicle
Wiring Details for your
2010-2011 Gmc Terrain Wiring Diagram |
Printer Friendly
Version |
|
|
Listed below is the vehicle specific wiring diagram for your car alarm, remote starter or keyless entry installation into your 2010-2011 Gmc Terrain . This information outlines the wires location, color and polarity to help you identify the proper connection spots in the vehicle. Please be sure to test all of your wires with a digital multimeter before making any connections. More information on using a multimeter and testing wires please see our Technical Support Area.
|
|
|
 |
| PART |
COLOR |
LOCATION |
| 12 VOLT
CONSTANT |
RED/WHITE (+) |
@ BCM, (LT. BLUE Plug) Pin 4, Note #2 |
| STARTER |
See NOTE #1 |
|
| STARTER
2 |
N/A |
|
| IGNITION
1 |
PINK (+) |
@ BCM, LT. GREEN 25-PIN PLUG, PIN 6, Note #2 |
| IGNITION
2 |
N/A |
|
| IGNITION
3 |
N/A |
|
| ACCESSORY/HEATER
BLOWER 1 |
BROWN (+) |
@ BCM, LT. GREEN 25-PIN PLUG, PIN 5, Note #2 |
| ACCESSORY/HEATER
BLOWER 2 |
N/A |
|
| KEYSENSE |
N/A |
|
| PARKING
LIGHTS ( - ) |
LT. BLUE (-) |
@ BCM, (WHITE 26-PIN Plug) Pin 22, Note #2 |
| PARKING
LIGHTS ( + ) |
N/A |
|
| POWER LOCK |
PINK/BLACK (TYPE B) |
@ BCM, (LT. BLUE 27-PIN Plug) Pin 19, Note #2 |
| POWER UNLOCK |
ORANGE/BLACK (TYPE B) |
@ BCM, (LT. BLUE 27-PIN Plug) Pin 15, Note #2 |
| DOOR TRIGGER |
GRAY/BLACK (-) |
@ DRIVERS WINDOW SWITCH, (BLACK 8-Pin Plug) Pin 6 |
| DOMELIGHT
SUPERVISION |
GRAY (+) |
@ BCM, (GRAY 26-PIN Plug) Pin 1, Note #2 |
| TRUNK RELEASE |
GRAY (-), Note #3 |
@ BCM, (PINK 27-PIN Plug) Pin 15, Note #2 |
| SLIDING
POWER DOOR |
N/A |
|
| HORN |
TAN (-) |
@ BCM, (TAN 26-PIN Plug) Pin 19, Note #2 |
| TACH |
Any BROWN, DK. BLUE, DK. GREEN, LT. BLUE, WHITE/DK. GREEN or PURPLE wire (AC) |
@ Any FUEL INJECTOR |
| WAIT TO
START LIGHT |
N/A |
|
| BRAKE |
WHITE (+) |
@ BCM, BLACK, 26-PIN PLUG, PIN 11, SEE NOTE #2 |
| FACTORY
ALARM DISARM |
DISARMS with FACTORY REMOTE ONLY!! |
|
| ANTI-THEFT |
GM'S MULTIPLEX IGNITION/TRANSPONDER SYSTEM, See NOTE #1 |
|
| EXTRA
INFORMATION |
| NOTE #1: THIS VEHICLE REQUIRES A SPECIAL INTERFACE BYPASS MODULE TO REMOTE START
PART # DB-ALL, TO ORDER GO TO THE INTERFACE BYPASS MODULE PAGE ON THIS
WEBSITE
Note #2: The BCM, (Body Control Module) is located under the Drivers Side of the Dash.
Note #3: TEST this wire while opening the Liftgate from the Liftgate Handle on the Rear
of the Vehicle. On vehicles with Power Liftgate, use the GRAY/BLACK (-) thru a 4.12k
Ohm Resistor, at the Release Switch on the Overhead Console,
(BLACK 4-Pin Plug) Pin 4
|
|
|
|
|
|
