Vehicle
Wiring Details for your
2009-2012 Ford Expedition Wiring Diagram |
Printer Friendly
Version |
|
|
Listed below is the vehicle specific wiring diagram for your car alarm, remote starter or keyless entry installation into your 2009-2012 Ford Expedition . This information outlines the wires location, color and polarity to help you identify the proper connection spots in the vehicle. Please be sure to test all of your wires with a digital multimeter before making any connections. More information on using a multimeter and testing wires please see our Technical Support Area.
|
|
|
 |
| PART |
COLOR |
LOCATION |
| 12 VOLT
CONSTANT |
RED (+) |
@ SJB, BLACK 1-PIN PLUG (G) Pin 1, Note #2 |
| STARTER |
BLUE/WHITE (+) |
@ IGNITION SWITCH, GRAY 10-PIN PLUG, Pin 10 |
| STARTER
2 |
N/A |
|
| IGNITION
1 |
WHITE/ORANGE (+) |
@ IGNITION SWITCH, GRAY 10-PIN PLUG, Pin 1 |
| IGNITION
2 |
N/A |
|
| IGNITION
3 |
N/A |
|
| ACCESSORY/HEATER
BLOWER 1 |
BROWN/YELLOW (+) |
@ IGNITION SWITCH, GRAY 10-PIN PLUG, Pin 7 |
| ACCESSORY/HEATER
BLOWER 2 |
PURPLE/GREEN (+) |
@ IGNITION SWITCH, GRAY 10-PIN PLUG, Pin 5 |
| KEYSENSE |
N/A |
|
| PARKING
LIGHTS ( - ) |
N/A |
|
| PARKING
LIGHTS ( + ) |
PURPLE/WHITE (+) |
@ SJB, GRAY 13-PIN PLUG(E), PIN 6, Note #2 |
| POWER LOCK |
WHITE/BROWN (TYPE B) |
in DRIVERS KICK PANEL or SJB, GRAY 26-PIN PLUG(C) Pin 17, Note #2 |
| POWER UNLOCK |
BLUE/BROWN (TYPE B) |
in DRIVERS KICK PANEL or SJB, GRAY 26-PIN PLUG(C) Pin 4, Note #2 |
| DOOR TRIGGER |
GREEN/PURPLE (-) |
@ SJB, GRAY 26-PIN PLUG(C) Pin 14, Note #2 |
| DOMELIGHT
SUPERVISION |
GRAY/PURPLE (+) |
@ SJB, GRAY 14-PIN PLUG(A) Pin 9, Note #2 |
| TRUNK RELEASE |
BROWN (-) (Liftgate), BROWN/YELLOW (-) (Glass), Note #3 |
@ SJB, GRAY 26-PIN PLUG(C) Pins 7 and 20, Note #2 |
| SLIDING
POWER DOOR |
N/A |
|
| HORN |
YELLOW/RED (-) |
@ HORN SWITCH or SJB, BLACK 52-PIN PLUG(B) Pin 41, Note #2 |
| TACH |
Any wire NOT BLUE (AC) |
@ Any FUEL INJECTOR |
| WAIT TO
START LIGHT |
N/A |
|
| BRAKE |
YELLOW/GRAY (+) |
@ BRAKE SWITCH or SJB, BLACK 52-PIN PLUG(B) Pin 40, Note #2 |
| FACTORY
ALARM DISARM |
N/A |
|
| ANTI-THEFT |
FORDS TRANSPONDER ANTI-THEFT SYSTEM, See NOTE #1 |
@ IGNITION SWITCH TUMBLER |
| EXTRA
INFORMATION |
| NOTE #1: This vehicle is equipped with a Special Anti-theft key, to remote start you will need a
Bypass module 791,(use this module IF you have a extra ignition key to place inside
the 791 to remote start, if you do not have an extra key to use or wish not to have a
key placed inside this bypass module, we OFFER a KEYLESS INTERFACE BYPASS
MODULE that does not require a key to be placed inside the bypass modlue, this is
Part # PKALL or PKFX, either one will work, to order, go to the INTERFACE BYPASS
MODULE PAGE on this website. If 2011-2012 and shaft of key has "SA" stamped into
the metal this is Fords new 80bit key and will require a PKTX interface module.
Note #2: The SJB, (Smart Junction Box) is located in the Passenger Kick Panel.
Note #3: TEST these wires while opening with the Handle on the Rear of the Vehicle. On
vehicles with Power Liftgate the Open/Close wire is a GRAY/YELLOW (-) @ the
Power Liftgate Switch on the Dash or in the DRIVERS KICK PANEL, Harness to
Rear of Vehicle.
|
|
|
|
|
|
