Vehicle
Wiring Details for your
2009-2012 Ford E-Series Wiring Diagram |
Printer Friendly Version |
|
|
Listed below is the vehicle specific wiring diagram for your car alarm, remote starter or keyless entry installation into your 2009-2012 Ford E-Series . This information outlines the wires location, color and polarity to help you identify the proper connection spots in the vehicle. Please be sure to test all of your wires with a digital multimeter before making any connections. More information on using a multimeter and testing wires please see our Technical Support Area.
|
|
|
|
PART |
COLOR |
LOCATION |
12 VOLT
CONSTANT |
RED (+) |
@ SJB, BLACK 1-PIN PLUG(G), PIN 1, SEE NOTE #2 |
STARTER |
BLUE/WHITE (+) |
@ IGNITION SWITCH, GRAY 13-PIN PLUG, PIN 5 |
STARTER
2 |
N/A |
|
IGNITION
1 |
WHITE/ORANGE (+) |
@ IGNITION SWITCH, GRAY 13-PIN PLUG, PIN 1 |
IGNITION
2 |
N/A |
|
IGNITION
3 |
N/A |
|
ACCESSORY/HEATER
BLOWER 1 |
BROWN/YELLOW (+) |
@ IGNITION SWITCH, GRAY 13-PIN PLUG, PIN 8 |
ACCESSORY/HEATER
BLOWER 2 |
PURPLE/GREEN (+) |
@ IGNITION SWITCH, GRAY 13-PIN PLUG, PIN 3 |
KEYSENSE |
N/A |
|
PARKING
LIGHTS ( - ) |
N/A |
|
PARKING
LIGHTS ( + ) |
PURPLE/WHITE (+) |
IN DRIVERS KICK PANEL or SJB, GRAY 13-PIN PLUG(E), PIN 6, SEE NOTE #2 |
POWER LOCK |
GRAY/YELLOW (TYPE B) |
IN DRIVERS KICK PANEL or SJB, GRAY 26-PIN PLUG(C), PIN 17, SEE NOTE #2 |
POWER UNLOCK |
PURPLE/GRAY (TYPE B) |
IN DRIVERS KICK PANEL or SJB, GRAY 26-PIN PLUG(C), PIN 4, SEE NOTE #2 |
DOOR TRIGGER |
GREEN/PURPLE (-) |
IN DRIVERS KICK PANEL or SJB, GRAY 26-PIN PLUG(C), PIN 14, SEE NOTE #2 |
DOMELIGHT
SUPERVISION |
GRAY/PURPLE (+) |
IN DRIVERS KICK PANEL or SJB, GRAY 14-PIN PLUG(A), PIN 9, SEE NOTE #2 |
TRUNK RELEASE |
N/A |
|
SLIDING
POWER DOOR |
N/A |
|
HORN |
BLUE/WHITE (-) |
@ HORN SWITCH or SJB, BLACK 52-PIN PLUG(B), PIN 41, SEE NOTE #2 |
TACH |
Any wire NOT BLUE (AC) |
@ ANY FUEL-INJECTOR |
WAIT TO
START LIGHT |
N/A |
|
BRAKE |
PURPLE/WHITE (+) |
@ SWITCH ABOVE BRAKE PEDAL |
FACTORY
ALARM DISARM |
N/A |
|
ANTI-THEFT |
FORDS TRANSPONDER ANTI-THEFT SYSTEM, See NOTE #1 |
@ IGNITION TUMBLER |
EXTRA
INFORMATION |
NOTE #1: This vehicle is equipped with a Special Anti-theft key, to remote start you will need a
Bypass module 791,(use this module IF you have a extra ignition key to place inside
the 791 to remote start, if you do not have an extra key to use or wish not to have a
key placed inside this bypass module, we OFFER a KEYLESS INTERFACE BYPASS
MODULE that does not require a key to be placed inside the bypass modlue, this is
Part # PKALL or PKTX, either one will work, to order, go to the INTERFACE BYPASS
MODULE PAGE on this website.
NOTE #2: The SJB (Smart Junction Box) is located under the Drivers Dash.
|
|
|
|
|