Vehicle
Wiring Details for your
2009-2011 Lexus GS350 Wiring Diagram |
Printer Friendly Version |
|
|
Listed below is the vehicle specific wiring diagram for your car alarm, remote starter or keyless entry installation into your 2009-2011 Lexus GS350 . This information outlines the wires location, color and polarity to help you identify the proper connection spots in the vehicle. Please be sure to test all of your wires with a digital multimeter before making any connections. More information on using a multimeter and testing wires please see our Technical Support Area.
|
|
|
|
PART |
COLOR |
LOCATION |
12 VOLT
CONSTANT |
WHITE (+) |
@ DRIVERS DASH FUSE BOX, (WHITE, 1-PIN PLUG) PIN 1 |
STARTER |
PINK (-) |
@ ENGINE SWITCH, (BLACK, 14-PIN PLUG) PIN 7 |
STARTER
2 |
BLACK (-) |
@ ENGINE SWITCH, (BLACK, 14-PIN PLUG) PIN 2 |
IGNITION
1 |
WHITE (+) |
@ PASSENGER DASH FUSE BOX, (GRAY, 10-PIN PLUG(K) PIN 3 |
IGNITION
2 |
LT. BLUE (+) |
@ PASSENGER DASH FUSE BOX, (REAR, WHITE, 32-PIN PLUG) PIN 6 |
IGNITION
3 |
N/A |
|
ACCESSORY/HEATER
BLOWER 1 |
GREEN (+) |
@ PASSENGER DASH FUSE BOX, (REAR, WHITE, 32-PIN PLUG) PIN 2 |
ACCESSORY/HEATER
BLOWER 2 |
N/A |
|
KEYSENSE |
N/A |
|
PARKING
LIGHTS ( - ) |
BLUE (-) |
@ HEADLIGHT SWITCH, (WHITE, 20-PIN PLUG) PIN 18 |
PARKING
LIGHTS ( + ) |
GREEN (+) (Front) NOTE #9 |
@ (LH) HEADLIGHT or ENGINE COMPARTMENT FUSE BOX, (BLACK, 13-PIN PLUG) PIN 9 |
POWER LOCK |
BLUE (TYPE B), (TEST with PASSENGER Switch) NOTE #2 |
@ FRONT (RH) DOOR ECU, (WHITE, 24-PIN LUG) PIN 22, in PASSENGER DOOR |
POWER UNLOCK |
GREEN (TYPE B), (TEST with PASSENGER Switch) NOTE #3 |
@ FRONT (RH) DOOR ECU, (WHITE, 24-PIN LUG) PIN 23, in PASSENGER DOOR |
DOOR TRIGGER |
RED (-) |
@ BECU (RH), (WHITE, 16-PIN PLUG) PIN 14, NOTE #7 |
DOMELIGHT
SUPERVISION |
BLUE (-) |
@ BECU (LH), (WHITE, 10-PIN PLUG) PIN 2, NOTE #8 |
TRUNK RELEASE |
BLUE (-) |
@ RELEASE SWITCH, (BLACK, 5-PIN PLUG) PIN 4 or BECU (RH), (WHITE, 26-PIN PLUG) PIN 21, NOTE #7 |
SLIDING
POWER DOOR |
N/A |
|
HORN |
YELLOW (-) |
@ HORN SWITCH, (BLACK, 12-PIN PLUG) PIN 8 |
TACH |
WHITE (AC) |
@ DATA LINK Connector, (WHITE, 16-PIN PLUG) PIN 9, under the Drivers Dash |
WAIT TO
START LIGHT |
N/A |
|
BRAKE |
RED/BLACK (+) |
@ BRAKE SWITCH or PASSENGER DASH FUSE BOX, (GRAY, 10-PIN PLUG(K) PIN 1 |
FACTORY
ALARM DISARM |
PINK (-) Requires Double Pulse, NOTE #4 |
@ POWER WINDOW MASTER SWITCH, 20-PIN PLUG) PIN 13 |
ANTI-THEFT |
TOYOTA'S TRANSPONDER SYSTEM, See NOTE #1 |
|
EXTRA
INFORMATION |
NOTE #1: LEXUS TRANSPONDER ANTI-THEFT SYSTEM, Requires Bypass Module,
Part # 791 Bypass Module (for REMOTE STARTING ONLY!) an Extra Ignition key is
required to be placed inside this module for Operation.
Part # PK-ALL Bypass Module (for REMOTE STARTING ONLY!) KEYLESS BYPASS
NO KEY is required for Operation.
To order the Bypass Module go to the INTERFACE BYPASS MODULE Page on this
website
NOTE #2: this wire is only needed if the Door Locks do not function with the Aftermarket System
while the vehicle is running. All other times just use the Factory Alarm Arm wire.
NOTE #3: this wire is only needed if the Door Locks do not function with the Aftermarket System
while the vehicle is running. All other times just use the Factory Alarm Disarm wire.
NOTE #4: TEST this wire while turning the Key in the Drivers Door, this wire will also Unlock
the Doors.
NOTE #5: the PSCU, (Power Source Control Unit) is the Module, on the far RIGHT, behind
the GLOVE BOX.
NOTE #6: TEST this wire while opening the Trunk with the Handle on the Rear of the vehicle.
NOTE #7: the BECU (RH) (Body Electronic Control Unit) (Right Hand) is part of the PASSENGER
SIDE FUSE BOX, attached to the Right side.
NOTE #8: the BECU (LH) (Body Electronic Control Unit) (Left Hand) is on the Right side of the
DRIVERS SIDE FUSE BOX, under the DRIVERS DASH
NOTE #9: the REAR (LH) TAILLIGHT is PURPLE (+) and the REAR (RH) TAILLIGHT is BROWN(+)
@ the LUGGAGE COMPARTMENT FUSE BOX, (WHITE, 22-PIN PLUG) PINS 8 and 22
|
|
|
|
|