Vehicle
Wiring Details for your
2009-2011 Hyundai Genesis Wiring Diagram |
Printer Friendly Version |
|
|
Listed below is the vehicle specific wiring diagram for your car alarm, remote starter or keyless entry installation into your 2009-2011 Hyundai Genesis . This information outlines the wires location, color and polarity to help you identify the proper connection spots in the vehicle. Please be sure to test all of your wires with a digital multimeter before making any connections. More information on using a multimeter and testing wires please see our Technical Support Area.
|
|
|
|
PART |
COLOR |
LOCATION |
12 VOLT
CONSTANT |
RED (+) 40 AMP, NOTE #2 |
@ IGNITION SWITCH, (WHITE, 6-PIN PLUG), PIN 2 |
STARTER |
YELLOW (+) NOTE #3 |
@ IGNITION SWITCH, (WHITE, 6-PIN PLUG), PIN 1 |
STARTER
2 |
ORANGE/BLACK(+)(SW1), WHITE(+)(SW2) (SMART KEY) |
@ START/STOP BUTTON SWITCH, (BLACK, 10-PIN PLUG), PINS 1 and 7 |
IGNITION
1 |
WHITE (+), NOTE #4 |
@ IGNITION SWITCH, (WHITE, 6-PIN PLUG), PIN 6 |
IGNITION
2 |
N/A |
|
IGNITION
3 |
N/A |
|
ACCESSORY/HEATER
BLOWER 1 |
GREEN (+), NOTE #5 |
@ IGNITION SWITCH, (WHITE, 6-PIN PLUG), PIN 3 |
ACCESSORY/HEATER
BLOWER 2 |
ORANGE (+), NOTE #6 |
@ IGNITION SWITCH, (WHITE, 6-PIN PLUG), PIN 4 |
KEYSENSE |
N/A |
|
PARKING
LIGHTS ( - ) |
N/A |
|
PARKING
LIGHTS ( + ) |
BROWN(+)(Left) and WHITE(+)(Right) use both |
in PASSENGER KICK PANEL, (BLACK, 21-PIN PLUG), PINS 2 and 1 |
POWER LOCK |
GREEN(-) and PINK/BLACK(Open), NOTE #7 |
@ DDM, (BLACK, 20-PIN PLUG), PIN 18 and (BLACK, 16-PIN PLUG) PIN 11, NOTE #9 |
POWER UNLOCK |
RED/ORANGE(-) and PINK/BLACK(-), NOTE #8 |
@ DDM, (BLACK, 20-PIN PLUG), PIN 19 and (BLACK, 16-PIN PLUG) PIN 11, NOTE #9 |
DOOR TRIGGER |
GREEN (-) |
@ IPM, (WHITE, 26-PIN PLUG), PIN 24, NOTE #10 |
DOMELIGHT
SUPERVISION |
BLACK/ORANGE (-) |
in DRIVERS KICK PANEL, (WHITE, 76-PIN PLUG), PIN 11 |
TRUNK RELEASE |
PINK (-), NOTE #11 |
@ IPM, (WHITE, 26-PIN PLUG), PIN 8, NOTE #10 |
SLIDING
POWER DOOR |
N/A |
|
HORN |
GREEN/ORANGE (-) |
in DRIVERS KICK PANEL, (WHITE, 31-PIN PLUG), PIN 24 |
TACH |
(NON-COMMON WIRE) (AC) |
@ Any FUEL-INJECTOR |
WAIT TO
START LIGHT |
N/A |
|
BRAKE |
GRAY or WHITE/ORANGE (+) |
@ BRAKE PEDAL SWITCH or in DRIVERS KICK PANEL, (BLUE, 39-PIN PLUG), PIN 14 |
FACTORY
ALARM DISARM |
Use UNLOCK wires |
|
ANTI-THEFT |
HYUNDAI'S TRANSPONDER ANTI-THEFT SYSTEM, See NOTE #1 |
@ IGNITION SWITCH TUMBLER |
EXTRA
INFORMATION |
NOTE #1: This vehicle May Be Equipped with HYUNDAI'S TRANSPONDER ANTI-THEFT SYSTEM,
check the OWNERS MANUAL for this vehcile or contact your HYUNDAI Dealer to see if
the vehicle has a Special programmed Ignition Key, if it does, then for REMOTE
STARTING you will need the 791 BYPASS Module and an Extra Ignition key.
To Order the 791 go to the SECURITY BYPASS MODULE Page on this website.
NOTE #2: on Vehicles with SMART KEY, use WHITE (+) 60 AMP, at the DRIVERS DASH FUSE
BOX, (REAR WHITE, 1-PIN PLUG(B), PIN 1.
NOTE #3: on Vehicles with SMART KEY, use YELLOW (+), at the PDM, (BLACK, 10-PIN PLUG),
PIN 6. the PDM, (Power distibution Module) is under the DRIVERS DASH and to the
RIGHT of the STEERING COLUMN, attached to the CENTER DASH SUPPORT.
NOTE #4: on Vehicles with SMART KEY, use YELLOW/ORANGE (+), at the PDM, (BLACK, 10-PIN
PLUG), PIN 7. the PDM, (Power distibution Module) is under the DRIVERS DASH and to
the RIGHT of the STEERING COLUMN, attached to the CENTER DASH SUPPORT.
NOTE #5: on Vehicles with SMART KEY, use ORANGE/BLACK (+), at the PDM, (BLACK, 10-PIN
PLUG), PIN 8. the PDM, (Power distibution Module) is under the DRIVERS DASH and to
the RIGHT of the STEERING COLUMN, attached to the CENTER DASH SUPPORT.
NOTE #6: on Vehicles with SMART KEY, use RED/BLACK (+), at the PDM, (BLACK, 10-PIN
PLUG), PIN 9. the PDM, (Power distibution Module) is under the DRIVERS DASH and to
the RIGHT of the STEERING COLUMN, attached to the CENTER DASH SUPPORT.
NOTE #7: the LOCK wires are GREEN (-), TYPE B and PINK/BLACK (Open this wire). TEST both
wires while Turning the KEY in the DRIVERS DOOR.
NOTE #8: the UNLOCK wires are RED/ORANGE (-), TYPE B and PINK/BLACK (-) TYPE B, use both.
TEST both wires while Turning the KEY in the DRIVERS DOOR.
NOTE #9: the DDM, (Drivers Door Module) is part of the POWER WINDOW MAIN SWITCH, in the
DRIVERS DOOR.
NOTE #10: the IPM, (Instrument Panel Module) is located under the DRIVERS SIDE of the DASH
and to the LEFT of the STEERING COLUMN.
NOTE #11: TEST this wire while Opening the TRUNK from the Handle on the REAR of the Vehicle
|
|
|
|
|