Vehicle
Wiring Details for your
2009-2011 Honda Element Wiring Diagram |
Printer Friendly Version |
|
|
Listed below is the vehicle specific wiring diagram for your car alarm, remote starter or keyless entry installation into your 2009-2011 Honda Element . This information outlines the wires location, color and polarity to help you identify the proper connection spots in the vehicle. Please be sure to test all of your wires with a digital multimeter before making any connections. More information on using a multimeter and testing wires please see our Technical Support Area.
|
|
|
|
PART |
COLOR |
LOCATION |
12 VOLT
CONSTANT |
WHITE (+) 50 AMP |
@ IGNITION SWITCH, (BROWN, 7-Pin Plug) Pin 3 |
STARTER |
BLACK/WHITE (+) |
@ IGNITION SWITCH, (BROWN, 7-Pin Plug) Pin 1 |
STARTER
2 |
N/A |
|
IGNITION
1 |
BLACK/YELLOW (+) |
@ IGNITION SWITCH, (BROWN, 7-Pin Plug) Pin 6 |
IGNITION
2 |
N/A |
|
IGNITION
3 |
N/A |
|
ACCESSORY/HEATER
BLOWER 1 |
BLACK/RED (+) |
@ IGNITION SWITCH, (BROWN, 7-Pin Plug) Pin 4 |
ACCESSORY/HEATER
BLOWER 2 |
WHITE/RED (+) |
@ IGNITION SWITCH, (BROWN, 7-Pin Plug) Pin 5 |
KEYSENSE |
N/A |
|
PARKING
LIGHTS ( - ) |
BLUE (-) |
@ SCU, (GREEN, 22-Pin Plug) Pin 9, NOTE #2 |
PARKING
LIGHTS ( + ) |
RED/YELLOW (+) |
@ DASH FUSE BOX, (LT. GREEN, 18-Pin Plug(P) Pin 15 |
POWER LOCK |
WHITE/BLUE (TYPE B) |
Above DRIVERS KICK PANEL, (GRAY, 20-Pin Plug) Pin 18 |
POWER UNLOCK |
WHITE/GREEN (TYPE B) |
Above DRIVERS KICK PANEL, (GRAY, 20-Pin Plug) Pin 19 |
DOOR TRIGGER |
GREEN (-) |
@ SCU, (GREEN, 22-Pin Plug) Pin 3, NOTE #2 |
DOMELIGHT
SUPERVISION |
GREEN/RED (-) |
@ DASH FUSE BOX, (Rear,LT. GREEN, 12-Pin Plug(O) Pin 7 |
TRUNK RELEASE |
LOCKS/UNLOCKS with Doors. |
|
SLIDING
POWER DOOR |
N/A |
|
HORN |
ORANGE (-) |
@ SCU, (GREEN, 22-Pin Plug) Pin 6, NOTE #2 |
TACH |
Any wire NOT YELLOW/BLACK (AC) |
@ Any FUEL-INJECTOR |
WAIT TO
START LIGHT |
N/A |
|
BRAKE |
WHITE/BLACK (+) |
@ BRAKE SWITCH or DASH FUSE BOX, (LT. GREEN, 18-Pin Plug(P) Pin 8 |
FACTORY
ALARM DISARM |
DISARMS with FACTORY REMOTE ONLY!! |
|
ANTI-THEFT |
HONDA'S TRANSPONDER SYSTEM, Requires Bypass Module, See NOTE #1 |
@ IGNITION SWITCH TUMBLER |
EXTRA
INFORMATION |
NOTE #1: HONDA'S TRANSPONDER SYSTEM, Requires Bypass Module:
(For Remote Starting Only) Part #791 Bypass, (Requires Extra Key) for Operation.
(For Remote Starting Only) Part # PK-ALL Bypass. (No Extra Key Required for
Operation) 2-KEYS Required to Program Module.
(For Remote Starting/Door Locks) Part # DB-ALL (No Extra Key Required for Operation)
1-KEY Required for Programming.
To order please go to the SECURITY BYPASS MODULE Page or INTERFACE BYPASS
MODULE Page on this website.
NOTE #2: the SCU (Security control Module) is located under the Drivers Dash and to the Left of
the Brake Switch. If the vehicle is not equiped with this Module, there will be an Open plug.
|
|
|
|
|