Vehicle
Wiring Details for your
2009-2011 Chevrolet Impala Wiring Diagram |
Printer Friendly Version |
|
|
Listed below is the vehicle specific wiring diagram for your car alarm, remote starter or keyless entry installation into your 2009-2011 Chevrolet Impala . This information outlines the wires location, color and polarity to help you identify the proper connection spots in the vehicle. Please be sure to test all of your wires with a digital multimeter before making any connections. More information on using a multimeter and testing wires please see our Technical Support Area.
|
|
|
 |
PART |
COLOR |
LOCATION |
12 VOLT
CONSTANT |
RED/WHITE (+) |
@ BCM, BLACK PLUG, PIN 1, SEE NOTE #2 |
STARTER |
SEE NOTE #1 |
|
STARTER
2 |
N/A |
|
IGNITION
1 |
PINK (+) |
@ IGNITION SWITCH HARNESS or BCM, LT. GREEN PLUG, PIN 14, SEE NOTE #2 |
IGNITION
2 |
N/A |
|
IGNITION
3 |
N/A |
|
ACCESSORY/HEATER
BLOWER 1 |
BROWN (+) |
@ IGNITION SWITCH HARNESS or BCM, LT. GREEN PLUG, PIN 21, SEE NOTE #2 |
ACCESSORY/HEATER
BLOWER 2 |
N/A |
|
KEYSENSE |
N/A |
|
PARKING
LIGHTS ( - ) |
BROWN/WHITE (-) |
@ BCM, WHITE PLUG, PIN 8, SEE NOTE #2 |
PARKING
LIGHTS ( + ) |
N/A |
|
POWER LOCK |
PINK/BLACK (TYPE B) |
@ BCM, GRAY PLUG, PIN 12, SEE NOTE #2 |
POWER UNLOCK |
ORANGE/BLACK (TYPE B) |
@ BCM, GRAY PLUG, PIN 11, SEE NOTE #2 |
DOOR TRIGGER |
TAN (-) |
@ BCM, GRAY PLUG, PIN 23, SEE NOTE #2 |
DOMELIGHT
SUPERVISION |
GRAY/BLACK (+) |
@ BCM, PINK PLUG, PIN 1, SEE NOTE #2 |
TRUNK RELEASE |
LT. BLUE (-) |
@ BCM, WHITE PLUG, PIN 10, SEE NOTE #2 |
SLIDING
POWER DOOR |
N/N |
|
HORN |
TAN (-) |
@ BCM, BROWN PLUG, PIN 18, SEE NOTE #2 |
TACH |
SEE NOTE #3 |
@ ANY FUEL-INJECTOR |
WAIT TO
START LIGHT |
N/A |
|
BRAKE |
LT. BLUE (+) |
@ BCM, BROWN PLUG, PIN 5, SEE NOTE #2 |
FACTORY
ALARM DISARM |
PURPLE (-) SEE NOTE #4 |
@ BCM, PINK PLUG, PIN 20, SEE NOTE #2 |
ANTI-THEFT |
GM'S MULTIPLEX IGNITION/ANTI-THEFT SYSTEM, See NOTE #1 |
|
EXTRA
INFORMATION |
NOTE #1: This Vehicle is equipped with GM'S MULTIPLEX IGNITION/ANTI-THEFT SYSTEM that
Requires a Special INTERFACE BYPASS MODULE to REMOTE START due to its Multiplex
Ignition System, Part # DB-ALL or XK09, Either module will also require part #
RFLCHGM,
to order please go to the INTERFACE BYPASS MODULE Page on this website.
NOTE #2: The BCM is located UNDER the drivers dash and to the LEFT of the Steering Column.
NOTE #3: For the TACH wire on the V6, use any wire NOT PINK at any FUEL-INJECTOR, on the
V8 use any wire NOT PINK/BLACK (AC) at any FUEL-INJECTOR.
NOTE #4: This wire is only needed IF the alarm sounds when unlocking or Remote Starting, when testing this wire make sure you are turning the key in the drivers door key cylinder.
|
|
|
|
|