Vehicle
Wiring Details for your
2008-2011 Chevrolet Malibu Wiring Diagram |
Printer Friendly
Version |
|
|
Listed below is the vehicle specific wiring diagram for your car alarm, remote starter or keyless entry installation into your 2008-2011 Chevrolet Malibu . This information outlines the wires location, color and polarity to help you identify the proper connection spots in the vehicle. Please be sure to test all of your wires with a digital multimeter before making any connections. More information on using a multimeter and testing wires please see our Technical Support Area.
|
|
|
 |
| PART |
COLOR |
LOCATION |
| 12 VOLT
CONSTANT |
RED/BLACK (+) |
@ BCM, RED 41-PIN PLUG(X3), PIN D1, SEE NOTE #2 |
| STARTER |
SEE NOTE #1 |
|
| STARTER
2 |
N/A |
|
| IGNITION
1 |
PINK (+) |
@ IGNITION SWITCH HARNESS, GREEN 6-PIN PLUG, PIN 3 |
| IGNITION
2 |
N/A |
|
| IGNITION
3 |
N/A |
|
| ACCESSORY/HEATER
BLOWER 1 |
BROWN (+) |
@ IGNITION SWITCH HARNESS, GREEN 6-PIN PLUG, PIN 4 |
| ACCESSORY/HEATER
BLOWER 2 |
N/A |
|
| KEYSENSE |
N/A |
|
| PARKING
LIGHTS ( - ) |
BROWN/WHITE (-) |
@ HEADLIGHT SWITCH or BCM, GRAY 72-PIN PLUG(X2), PIN 5, SEE NOTE #2 |
| PARKING
LIGHTS ( + ) |
BROWN (+) |
IN DRIVERS KICK or BCM, RED 41-PIN PLUG(X3), PIN A7, SEE NOTE #2 |
| POWER LOCK |
SEE NOTE #1 |
|
| POWER UNLOCK |
SEE NOTE #1 |
|
| DOOR TRIGGER |
GRAY/BLACK (-) |
@ BCM, GRAY 72-PIN PLUG(X1), PIN 51, SEE NOTE #2 |
| DOMELIGHT
SUPERVISION |
GRAY (-) |
@ BCM, RED 41-PIN PLUG(X3), PIN A10, SEE NOTE #2 |
| TRUNK RELEASE |
BROWN/WHITE (-) |
@ TRUNK RELEASE SWITCH or BCM, GRAY 72-PIN PLUG(X1), PIN 71, SEE NOTE #2 |
| SLIDING
POWER DOOR |
N/A |
|
| HORN |
TAN (-) |
@ HORN SWITCH or BCM, GRAY 72-PIN PLUG(X2), PIN 14, SEE NOTE #2 |
| TACH |
Any wire NOT PINK or PINK/BLACK, (AC) |
@ ANY FUEL-INJECTOR |
| WAIT TO
START LIGHT |
N/A |
|
| BRAKE |
WHITE (+) |
@ BCM, GRAY 72-PIN PLUG(X1), PIN 42, SEE NOTE #2 |
| FACTORY
ALARM DISARM |
LT. GREEN (-) DISARMS WITH A (-) THRU A 500 OHM RESISTOR |
IN DRIVERS KICK or BCM, GRAY 72-PIN PLUG(X1), PIN 35, SEE NOTE #2 |
| ANTI-THEFT |
GM'S MULTIPLEX IGNITION/ANTI-THEFT SYSTEM, See NOTE #1 |
|
| EXTRA
INFORMATION |
| NOTE #1: This Vehicle Requires a Special INTERFACE BYPASS MODULE for the MULTIPLEX
Ignition System and Anti-theft System this also includes the Keyless Entry System,
part # DB-ALL or XK09, either will work,
to order please go to the INTERFACE BYPASS MODULE Page on this website.
NOTE #2 The BCM is part of the FUSE/RELAY BOX, on the Front Passenger side of the
Center Console.
NOTE #3: When installing an Alarm System use both wires and diode isolate.
|
|
|
|
|
|
