Vehicle
Wiring Details for your
2008-2011 Mitsubishi Eclipse Wiring Diagram |
Printer Friendly Version |
|
|
Listed below is the vehicle specific wiring diagram for your car alarm, remote starter or keyless entry installation into your 2008-2011 Mitsubishi Eclipse . This information outlines the wires location, color and polarity to help you identify the proper connection spots in the vehicle. Please be sure to test all of your wires with a digital multimeter before making any connections. More information on using a multimeter and testing wires please see our Technical Support Area.
|
|
|
|
PART |
COLOR |
LOCATION |
12 VOLT
CONSTANT |
BLUE/YELLOW (+) |
@ IGNITION SWITCH, (6-PIN PLUG), PIN 1 |
STARTER |
BLACK/YELLOW (+) |
@ IGNITION SWITCH, (6-PIN PLUG), PIN 5 |
STARTER
2 |
N/A |
|
IGNITION
1 |
RED (+) |
@ IGNITION SWITCH, (6-PIN PLUG), PIN 2 |
IGNITION
2 |
N/A |
|
IGNITION
3 |
N/A |
|
ACCESSORY/HEATER
BLOWER 1 |
BLUE/RED (+) |
@ IGNITION SWITCH, (6-PIN PLUG), PIN 4 |
ACCESSORY/HEATER
BLOWER 2 |
BLUE/BLACK (+) |
@ IGNITION SWITCH, (6-PIN PLUG), PIN 6 |
KEYSENSE |
N/A |
|
PARKING
LIGHTS ( - ) |
N/A |
|
PARKING
LIGHTS ( + ) |
GREEN/ORANGE (+)(Left) and GREEN/WHITE (+)(Right), (Requires 775 relay) |
in DRIVERS KICK PANEL(Left) or FUSE BOX, (BOTTOM, 15-PIN PLUG), PIN 2(Right) |
POWER LOCK |
PURPLE/WHITE (TYPE B) |
in DRIVERS KICK PANEL or ETACS-ECU, (WHITE, 24-PIN PLUG) PIN 13, NOTE #2 |
POWER UNLOCK |
LT. GREEN/RED (TYPE B) |
in DRIVERS KICK PANEL or ETACS-ECU, (WHITE, 24-PIN PLUG) PIN 14, NOTE #2 |
DOOR TRIGGER |
LT. GREEN (-) |
@ FUSE BOX, (BOTTOM, 15-PIN PLUG), PIN 6 |
DOMELIGHT
SUPERVISION |
GREEN/ORANGE (-) |
@ FUSE BOX, (BOTTOM, 3-PIN PLUG), PIN 1 |
TRUNK RELEASE |
RED (-), NOTE #3 |
in DRIVERS KICK PANEL or ETACS-ECU, (WHITE, 24-PIN PLUG) PIN 21, NOTE #2 |
SLIDING
POWER DOOR |
N/A |
|
HORN |
LT. GREEN (-) |
in DRIVERS KICK PANEL or ETACS-ECU, (WHITE, 24-PIN PLUG) PIN 24, NOTE #2 |
TACH |
Any wire NOT RED (AC) |
@ Any FUEL-INJECTOR |
WAIT TO
START LIGHT |
N/A |
|
BRAKE |
GREEN (+) |
@ BRAKE PEDAL SWITCH or in DRIVERS KICK PANEL, Harness to REAR of Vehicle |
FACTORY
ALARM DISARM |
DISARMS with FACTORY REMOTE ONLY!! |
|
ANTI-THEFT |
MITSUBISHI'S TRANSPONDER ANTI-THEFT SYSTEM, See NOTE #1 |
|
EXTRA
INFORMATION |
NOTE #1: MITSUBISHI'S TRANSPONDER ANTI-THEFT SYSTEM, Requires Bypass Module,
Part # 791 Bypass Module (for REMOTE STARTING ONLY!) an Extra Ignition key is
required to be placed inside this module for Operation.
Part # XK09 Bypass Module, this Module is a KEYLESS BYPASS MODULE and DOES
NOT require a Key to be placed inside the Module for Operation.
To order go to the INTERFACE BYPASS MODULE Page on this website.
NOTE #2: the ETACS-ECU, (Electronic Time and Alarm Control System ECU) is located under
the DRIVERS DASH, attached to the Back of the FUSE BOX, it has 2 Plugs on the
RIGHT side Edge.
NOTE #3: TEST this wire while Opening the Trunk/Hatch from the Handle on the REAR of the
Vehicle.
|
|
|
|
|