Vehicle
Wiring Details for your
2008-2009 Volkswagen Rabbit Wiring Diagram |
Printer Friendly
Version |
|
|
Listed below is the vehicle specific wiring diagram for your car alarm, remote starter or keyless entry installation into your 2008-2009 Volkswagen Rabbit . This information outlines the wires location, color and polarity to help you identify the proper connection spots in the vehicle. Please be sure to test all of your wires with a digital multimeter before making any connections. More information on using a multimeter and testing wires please see our Technical Support Area.
|
|
|
 |
| PART |
COLOR |
LOCATION |
| 12 VOLT
CONSTANT |
RED/BLACK (+) 40 AMP and RED/YELLOW (+) 30 AMP |
@ VESCM, (2-PIN PLUG(L), PIN 1, (11-PIN PLUG(A), PIN 1, NOTE #2 |
| STARTER |
RED/BLACK or RED/BROWN (+) |
@ VESCM, (12-PIN PLUG(G), PIN 1, NOTE #2 |
| STARTER
2 |
N/A |
|
| IGNITION
1 |
BLACK +) |
|
| IGNITION
2 |
N/A |
|
| IGNITION
3 |
N/A |
|
| ACCESSORY/HEATER
BLOWER 1 |
N/A |
|
| ACCESSORY/HEATER
BLOWER 2 |
N/A |
|
| KEYSENSE |
N/A |
|
| PARKING
LIGHTS ( - ) |
N/A |
|
| PARKING
LIGHTS ( + ) |
GRAY/YELLOW (+), NOTE #5 |
@ VESCM, (16-PIN PLUG(E), PIN 1, NOTE #2 |
| POWER LOCK |
BROWN/GREEN (-), NOTE #3 |
@ DDCM, (32-PIN PLUG), PIN 32, NOTE #4 |
| POWER UNLOCK |
Use LOCK wire, (-) thru a 250 Ohm Resistor |
|
| DOOR TRIGGER |
BROWN/YELLOW (-) |
@ DDCM, (20-PIN PLUG), PIN 7, NOTE #4 |
| DOMELIGHT
SUPERVISION |
RED/PURPLE (-) |
@ VESCM, (12-PIN PLUG(B), PIN 11, NOTE #2 |
| TRUNK RELEASE |
BLUE (-) |
@ DDCM, (32-PIN PLUG), PIN 30, NOTE #4 |
| SLIDING
POWER DOOR |
N/A |
|
| HORN |
BLACK/WHITE (+) |
@ VESCM, (6-PIN PLUG(J), PIN 6, NOTE #2 |
| TACH |
Any wire NOT RED/BLACK (AC) |
@ Any FUEL-INJECTOR |
| WAIT TO
START LIGHT |
N/A |
|
| BRAKE |
BLACK/RED (+), (TEST with IGNITION KEY ON) |
@ VESCM, (16-PIN PLUG(E), PIN 2, NOTE #2 |
| FACTORY
ALARM DISARM |
GREEN/WHITE (-) thru a 250 Ohm Resistor, NOTE #6 |
@ DDCM, (20-PIN PLUG), PIN 16, NOTE #4 |
| ANTI-THEFT |
VW'S TRANSPONDER ANTI-THEFT SYSTEM, Requires Bypass Module, See NOTE #1 |
@ IGNITION SWITCH TUMBLER |
| EXTRA
INFORMATION |
| NOTE #1: VW'S TRANSPONDER ANTI-THEFT SYSTEM, Requires Bypass Module,
Part # 791 Bypass Module, for REMOTE STARTING ONLY!
Part # DLPK-CANBUS MULTI for REMOTE STARTING and DOOR LOCKS (Resistors for
DOOR LOCKS, NOT REQUIRED)
NOTE #2: the VESCM, (Vehicle Electrical System Control Module) is the RELAY BOX, Under
the DRIVERS DASH.
NOTE #3: this vehicle uses a 1-WIRE DOOR LOCKING SYSTEM, that Requires Extra Parts for
operation. The use of Bypass Module DLPK-CANBUS MULTI will do the
ANTI-THEFT and DOOR LOCKS without the use of relays and resistors.
NOTE #4: the DDCM, (Drivers Door Control Module) is located in the DRIVERS DOOR.
NOTE #5: for the PARKING LIGHT FLASH option, it will be necessary to break the HEADLIGHT
Switch OFF wire, BLACK/YELLOW (+), located at the VESCM, (16-PIN PLUG(E), PIN 16.
NOTE #6: to DISARM FACTORY ALARM (if needed) Requires a (-) thru a 250 Ohm Resistor on
the GREEN/WHITE (-) wire, requires resistor and relay. TEST this wire while turning the
KEY in the DRIVERS DOOR.
|
|
|
|
|
|
