Vehicle
Wiring Details for your
2008-2009 Land Rover Lr 2 Wiring Diagram |
Printer Friendly
Version |
|
|
Listed below is the vehicle specific wiring diagram for your car alarm, remote starter or keyless entry installation into your 2008-2009 Land Rover Lr 2 . This information outlines the wires location, color and polarity to help you identify the proper connection spots in the vehicle. Please be sure to test all of your wires with a digital multimeter before making any connections. More information on using a multimeter and testing wires please see our Technical Support Area.
|
|
|
 |
| PART |
COLOR |
LOCATION |
| 12 VOLT
CONSTANT |
RED (+), 60 AMP |
@ CJB, (BLACK, 2-PIN PLUG), PIN 1, NOTE #2 |
| STARTER |
BLUE/WHITE (-), (PUSH-BUTTON START) |
@ SCU, (GRAY, 6-PIN PLUG), PIN 5 or CJB, (BLACK, 76-PIN PLUG(C), PIN 35, NOTE #2 and #3 |
| STARTER
2 |
N/A |
|
| IGNITION
1 |
BLUE (+), (NOT for REMOTE START!!), NOTE #1 |
@ CJB, (BLACK, 76-PIN PLUG(A), PIN 65, NOTE #2 |
| IGNITION
2 |
N/A |
|
| IGNITION
3 |
N/A |
|
| ACCESSORY/HEATER
BLOWER 1 |
YELLOW (+), (NOT for REMOTE START!!), NOTE #1 |
@ FRONT CIGAR LIGHTER |
| ACCESSORY/HEATER
BLOWER 2 |
N/A |
|
| KEYSENSE |
N/A |
|
| PARKING
LIGHTS ( - ) |
N/A |
|
| PARKING
LIGHTS ( + ) |
PURPLE/GREEN(+)(Left) and WHITE/ORANGE(+)(Right), use both, ISOLATE with RELAYS, NOTE #4 |
in PASSENGER KICK PANEL or CJB, (BLACK, 76-PIN PLUG(B), PINS 50 and 24, NOTE #2 |
| POWER LOCK |
GRAY/BROWN (-), TYPE B |
@ MASTER UNLOCK SWITCH or CJB, (BLACK, 76-PIN PLUG(C), PIN 33, NOTE #2 |
| POWER UNLOCK |
BROWN/GREEN (-), TYPE B |
@ MASTER UNLOCK SWITCH or CJB, (BLACK, 76-PIN PLUG(C), PIN 34, NOTE #2 |
| DOOR TRIGGER |
GREEN/PURPLE (-) |
in DRIVERS KICK PANEL or CJB, (BLACK, 76-PIN PLUG(B), PIN 7, NOTE #2 |
| DOMELIGHT
SUPERVISION |
BLUE (-) |
@ CJB, (BLACK, 20-PIN PLUG), PIN 20, NOTE #2 |
| TRUNK RELEASE |
BROWN (-) |
in PASSENGER KICK PANEL or CJB, (BLACK, 76-PIN PLUG(B), PIN 13, NOTE #2 |
| SLIDING
POWER DOOR |
N/A |
|
| HORN |
BLUE/WHITE (-) |
@ CJB, (BLACK, 76-PIN PLUG(A), PIN 46, NOTE #2 |
| TACH |
Any wire NOT WHITE (AC), NOTE #6 |
@ Any FUEL-INJECTOR |
| WAIT TO
START LIGHT |
N/A |
|
| BRAKE |
PURPLE/BROWN (+) |
@ BRAKE PEDAL SWITCH or CJB, (BLACK, 76-PIN PLUG(B), PIN 54, NOTE #2 |
| FACTORY
ALARM DISARM |
DISARMS with FACTORY REMOTE ONLY!! |
|
| ANTI-THEFT |
LAND ROVER'S TRANSPONDER ANTI-THEFT SYSTEM, Requires Bypass Module, See NOTE #1 |
@ IGNITION SWITCH TUMBLER |
| EXTRA
INFORMATION |
| NOTE #1: LAND ROVER'S TRANSPONDER ANTI-THEFT SYSTEM, Requires Bypass Module,
DUE to SPECIAL IGNITION CIRCUIT, MUST USE, Part # DLPK-CANBUS MULTI or
CANMAX 400 for REMOTE STARTING and KEYLESS ENTRY
NOTE #2: the CJB, (Central Junction Box) is located Behind the GLOVE BOX.
NOTE #3: the SCU, (Start Control Unit) is attached to the START/STOP Switch on the DRIVERS DASH.
NOTE #4: on Vehicles with HID Headlights, the FRONT Parking lights are separate. They are GREEN/ORANGE (+)(LEFT) BROWN/YELLOW(+)(Right) at the CJB, (BLACK, 76-PIN PLUG(A), PINS 13 and 41.
NOTE #5: the DDM, (Drivers Door Module) is located in the DRIVERS DOOR.
NOTE #6: for TACH Signal on DIESEL Vehicles, use PURPLE at the CAMSHAFT Posistion Sensor or the ECM, (BROWN PLUG), PIN 1. The ECM, (Engine Control Module) is located in the ENGINE COMPARTMENT on the TOP, CENTER of the FIREWALL.
|
|
|
|
|
|
