Vehicle
Wiring Details for your
2008-2009 Hyundai Tucson Wiring Diagram |
Printer Friendly
Version |
|
|
Listed below is the vehicle specific wiring diagram for your car alarm, remote starter or keyless entry installation into your 2008-2009 Hyundai Tucson . This information outlines the wires location, color and polarity to help you identify the proper connection spots in the vehicle. Please be sure to test all of your wires with a digital multimeter before making any connections. More information on using a multimeter and testing wires please see our Technical Support Area.
|
|
|
 |
| PART |
COLOR |
LOCATION |
| 12 VOLT
CONSTANT |
RED (+) or ORANGE (+) |
@ IGNITION SWITCH, (6-PIN PLUG), PIN 5 |
| STARTER |
PINK (+) |
@ IGNITION SWITCH, (6-PIN PLUG), PIN 1 |
| STARTER
2 |
N/A |
|
| IGNITION
1 |
ORANGE (+) |
@ IGNITION SWITCH, (6-PIN PLUG), PIN 6 |
| IGNITION
2 |
N/A |
|
| IGNITION
3 |
N/A |
|
| ACCESSORY/HEATER
BLOWER 1 |
PINK (+) |
@ IGNITION SWITCH, (6-PIN PLUG), PIN 3 |
| ACCESSORY/HEATER
BLOWER 2 |
YELLOW (+) |
@ IGNITION SWITCH, (6-PIN PLUG), PIN 4 |
| KEYSENSE |
N/A |
|
| PARKING
LIGHTS ( - ) |
BLUE/BLACK (-) or BLUE (-) |
@ HEADLIGHT SWITCH or ETACM, (24-PIN PLUG), PIN 18, NOTE #2 |
| PARKING
LIGHTS ( + ) |
PINK/BLACK(+)(Left) and BROWN/ORANGE(+)(Right) use both! |
@ FUSE BOX, (REAR, 18-PIN PLUG(F), PINS 10 and 3 |
| POWER LOCK |
WHITE/BLACK to GRAY(TYPE B), NOTE #3 |
in DRIVER KICK PANEL, (22-PIN PLUG), PIN 19 or RELAY above GAS PEDAL |
| POWER UNLOCK |
YELLOW/ORANGE to GREEN(TYPE B), NOTE #4 and #5 |
in DRIVER KICK PANEL, (22-PIN PLUG), PIN 20 or RELAY above GAS PEDAL |
| DOOR TRIGGER |
YELLOW/BLACK (-) |
in DRIVER KICK PANEL, (23-PIN PLUG), PIN 6 or ETACM, (24-PIN PLUG), PIN 17, NOTE #2 |
| DOMELIGHT
SUPERVISION |
YELLOW (-) |
@ FUSE BOX, (REAR, 10-PIN PLUG(H), PIN 2 or ETACM, (24-PIN PLUG), PIN 1, NOTE #2 |
| TRUNK RELEASE |
N/A |
|
| SLIDING
POWER DOOR |
N/A |
|
| HORN |
RED (-) |
@ HORN SWITCH or in DRIVERS KICK PANEL, (WHITE, 16-PIN PLUG), PIN 1 |
| TACH |
NOTE #6 (AC) |
@ Any FUEL-INJECTOR |
| WAIT TO
START LIGHT |
N/A |
|
| BRAKE |
WHITE (+) |
@ BRAKE PEDAL SWITCH or in DRIVERS KICK PANEL, (22-PIN PLUG), PIN 15 |
| FACTORY
ALARM DISARM |
BROWN (-), Requires Double Pulse, NOTE #7 |
in DRIVERS KICK PANEL, (20-PIN PLUG), PIN 9 or ETACM, (20-PIN PLUG), PIN 14 |
| ANTI-THEFT |
HYUNDAI'S TRANSPONDER ANTI-THEFT SYSTEM, See NOTE #1 |
@ IGNITION SWITCH TUMBLER |
| EXTRA
INFORMATION |
| NOTE #1: This vehicle May Be Equipped with HYUNDAI'S TRANSPONDER ANTI-THEFT SYSTEM,
check the OWNERS MANUAL for this vehcile or contact your HYUNDAI Dealer to see if
the vehicle has a Special programmed Ignition Key, if it does, then for REMOTE
STARTING you will need the 791 BYPASS Module and an Extra Ignition key.
To Order the 791 go to the SECURITY BYPASS MODULE Page on this website.
NOTE #2: the ETACM,(Electronic Time and Alarm Control Module) islocated in the Front Center
Console, below the Shift Lever.
NOTE #3: the LOCK wire is also a YELLOW/ORANGE (-) at the ETACM, (20-PIN PLUG), PIN 20,
See NOTE #2.
NOTE #4: the UNLOCK wire is also a YELLOW (-) at the ETACM, (20-PIN PLUG), PIN 9,
See NOTE #2.
NOTE #5: to UNLOCK just the DRIVERS DOOR, use the BLUE/ORANGE (-), at the RELAY, above
the GAS PEDAL or at the ETACM, (20-PIN PLUG), PIN 8, See NOTE #2
NOTE #6: when using a TACH wire, use any wire NOT WHITE(2.0L Engine) and
BROWN(2.7L Engine) both test (AC)
NOTE #7: TEST this wire while turning the KEY in the DRIVERS DOOR
|
|
|
|
|
|
