Vehicle
Wiring Details for your
2008-2009 Bmw 1 Series Wiring Diagram |
Printer Friendly Version |
|
|
Listed below is the vehicle specific wiring diagram for your car alarm, remote starter or keyless entry installation into your 2008-2009 Bmw 1 Series . This information outlines the wires location, color and polarity to help you identify the proper connection spots in the vehicle. Please be sure to test all of your wires with a digital multimeter before making any connections. More information on using a multimeter and testing wires please see our Technical Support Area.
|
|
|
|
PART |
COLOR |
LOCATION |
12 VOLT
CONSTANT |
RED/GREEN (+) and RED/PURPLE (+) |
@ FRM, (51-PIN PLUG(X14260), PIN 2 and (51-PINPLUG(X14261), PIN 34, NOTE #3 |
STARTER |
BLACK (+) Low Current (for STARTER KILL Only!) |
@ CAS, (41-PIN PLUG(X13376), PIN 22, NOTE #2 |
STARTER
2 |
N/A |
|
IGNITION
1 |
GREEN (+) (for IGNITION Sense Only!) |
@ CAS, (41-PIN PLUG(X13376), PIN 8, NOTE #2 |
IGNITION
2 |
N/A |
|
IGNITION
3 |
N/A |
|
ACCESSORY/HEATER
BLOWER 1 |
RED (+) (for ACCESSORY Sense Only!) |
@ CAS, (41-PIN PLUG(X13376), PIN 1, NOTE #2 |
ACCESSORY/HEATER
BLOWER 2 |
N/A |
|
KEYSENSE |
N/A |
|
PARKING
LIGHTS ( - ) |
N/A |
|
PARKING
LIGHTS ( + ) |
BLACK/GREEN(+)(Left Front) and BLACK/BLUE(+)(Right Front), use both, NOTE #4 |
@ FRM, (51-PIN PLUG(X14261), PIN 50 and (51-PINPLUG(X14260), PIN 8, NOTE #3 |
POWER LOCK |
YELLOW/RED (TYPE B) |
@ CENTRAL LOCK Switch or CAS, (41-PIN PLUG(X13376), PIN 29, NOTE #2 |
POWER UNLOCK |
Use LOCK wire |
|
DOOR TRIGGER |
BROWN/WHITE to BROWN/GRAY/WHITE (-) |
in DRIVERS KICK PANEL or FRM, (51-PIN PLUG(X14261), PIN 24, NOTE #3 |
DOMELIGHT
SUPERVISION |
RED/BLUE (-) (without ROOF FUNCTION CONTROL CENTER ONLY!), NOTE #8 |
@ FRM, (51-PIN PLUG(X14260), PIN 35, NOTE #3 |
TRUNK RELEASE |
GRAY/BROWN (-), NOTE #6 |
@ RELEASE Switch or CAS, (41-PIN PLUG(X13376), PIN 39, NOTE #2 |
SLIDING
POWER DOOR |
N/A |
|
HORN |
PURPLE/BLUE (+) |
@ JUNCTION BOX, PLUG(X11007), PIN 6 |
TACH |
BLACK (AC) |
@ DATA LINK Connector, (16-PIN PLUG), PIN 9 |
WAIT TO
START LIGHT |
N/A |
|
BRAKE |
BROWN/GRAY (+) (TEST with IGNITION KEY ON) |
@ BRAKE PEDAL Switch or CAS, (41-PIN PLUG(X13376), PIN 32, NOTE #2 |
FACTORY
ALARM DISARM |
WHITE/BLACK (-), NOTE #7 |
in DRIVERS KICK PANEL or FRM, (51-PIN PLUG(X14261), PIN 46, NOTE #3 |
ANTI-THEFT |
BMW'S TRANSPONDER ANTI-THEFT SYSTEM, See NOTE #1 |
@ IGNITION SWITCH TUMBLER |
EXTRA
INFORMATION |
NOTE #1: This vehicle requires a 791 Bypass Module and an extra ignition key for remote
starter operation.
to order go to the SECURITY BYPASS MODULE Page on this website.
NOTE #2: the CAS, (Car Access System) is located Under the DRIVERS DASH.
NOTE #3: the FRM, (Footwell Module), is located in the DRIVERS KICK PANEL.
NOTE #4: the LEFT REAR Parking Light wire is a GRAY/PURPLE(+), at the FRM, (51-PIN PLUG(X14260) PIN 16 and the RIGHT REAR Parking Light is a GRAY/YELLOW(+) at the FRM, (51-PIN PLUG(X14260) PIN 18, use ALL wires and Relay Isolate.
NOTE #5: the JBE, (Junction Box Electronics), is located behind the GLOVE BOX, attached
to the JUNCTION BOX.
NOTE #6: on WAGONS, the REAR GLASS RELEASE is BROWN/RED (-) at the JBE, (54-PIN PLUG(X14271), PIN 32.
NOTE #7: TEST this wire while Turning the KEY in the DRIVERS DOOR.
NOTE #8: on Vehicles with ROOF FUNCTION CONTROL CENTER, this wire is CAN BUS Controled!
|
|
|
|
|