Vehicle
Wiring Details for your
2008-2009 Audi TT Wiring Diagram |
Printer Friendly
Version |
|
|
Listed below is the vehicle specific wiring diagram for your car alarm, remote starter or keyless entry installation into your 2008-2009 Audi TT . This information outlines the wires location, color and polarity to help you identify the proper connection spots in the vehicle. Please be sure to test all of your wires with a digital multimeter before making any connections. More information on using a multimeter and testing wires please see our Technical Support Area.
|
|
|
 |
| PART |
COLOR |
LOCATION |
| 12 VOLT
CONSTANT |
RED (+) |
@ VESCM, (2-PIN PLUG(L), PIN 1, NOTE #2 |
| STARTER |
RED/BLACK (+) |
@ VESCM, (BLACK, 12-PIN PLUG(G), PIN 1, NOTE #2 |
| STARTER
2 |
N/A |
|
| IGNITION
1 |
BLACK/WHITE (+) |
@ VESCM, (BLACK, 12-PIN PLUG(G), PIN 11, NOTE #2 |
| IGNITION
2 |
N/A |
|
| IGNITION
3 |
N/A |
|
| ACCESSORY/HEATER
BLOWER 1 |
N/A |
|
| ACCESSORY/HEATER
BLOWER 2 |
N/A |
|
| KEYSENSE |
N/A |
|
| PARKING
LIGHTS ( - ) |
GRAY/YELLOW (-), NOTE #3 |
@ HEADLIGHT Switch or VESCM, (BLACK, 16-PIN PLUG(E), PIN 1, NOTE #2 |
| PARKING
LIGHTS ( + ) |
GRAY/BLACK(+)(Left Front) and GRAY/RED(+)(Right Front), NOTE #4 |
@ VESCM, (11-PIN PLUG(A), PIN 7 and (11-PIN PLUG(D), PIN 10, NOTE #2 |
| POWER LOCK |
PURPLE/BLUE (TYPE B) thru a Resistor, (Measure) |
@ DRIVERS DOOR CONTROL MODULE, (32-PIN PLUG), PIN 32 |
| POWER UNLOCK |
Use LOCK wire (TYPE B) thru a Resistor, (Measure) |
|
| DOOR TRIGGER |
GRAY/PURPLE (-) |
@ DRIVERS DOOR CONTROL MODULE, (20-PIN PLUG), PIN 17 or 7 |
| DOMELIGHT
SUPERVISION |
BLUE/GRAY (-) |
@ VESCM, (12-PIN PLUG(B), PIN 11, NOTE #2 |
| TRUNK RELEASE |
BROWN/PURPLE (-) |
@ DRIVERS DOOR CONTROL MODULE, (32-PIN PLUG), PIN 30 |
| SLIDING
POWER DOOR |
N/A |
|
| HORN |
BLACK/YELLOW (+) |
@ VESCM, (6-PIN PLUG(J), PIN 6, NOTE #2 |
| TACH |
NOTE #5 |
@ Any FUEL-INJECTOR |
| WAIT TO
START LIGHT |
N/A |
|
| BRAKE |
BLACK/YELLOW (+) |
@ BRAKE PEDAL Switch or VESCM, (BLACK, 16-PIN PLUG(E), PIN 2, NOTE #2 |
| FACTORY
ALARM DISARM |
BLUE/WHITE (-) |
@ DRIVERS DOOR CONTROL MODULE, (20-PIN PLUG), PIN 16 |
| ANTI-THEFT |
AUDI'S TRANSPONDER ANTI-THEFT SYSTEM, See NOTE #1 |
@ IGNITION SWITCH TUMBLER |
| EXTRA
INFORMATION |
| NOTE #1: AUDI'S TRANSPONDER ANTI-THEFT SYSTEM, Requires Bypass Module,
Part # 791 Bypass and an extra ignition key for REMOTE STARTING
Operation.
To order go to the SECURITY BYPASS MODULE Page on the website.
NOTE #2: the VESCM, (Vehicle Electronic System Control Module) is the RELAY BOX under the
DRIVERS DASH.
NOTE #3: when triggering this wire you will need to INTERRUPT the HEADLIGHT Switch OFF wire,
BLACK/WHITE at the HEADLIGHT Switch or VESCM,(BLACK, 16-PIN PLUG(E), PIN 16.
NOTE #4: the LEFT REAR Parking light is a GRAY/BLACK(+)at the VESCM, (12-PIN PLUG(C),
PIN 10, the RIGHT REAR Parking light is a GRAY/BLACK(+) at the VESCM, (12-PIN
PLUG(B), PIN 9
NOTE #5: when using the TACH wire, use any wire NOT RED STRIPE on the 2.0T and on the
3.2 NOT the RED/BLACK, all TEST (AC)
|
|
|
|
|
|
