Vehicle
Wiring Details for your
2007-2011 Hyundai Veracruz Wiring Diagram |
Printer Friendly
Version |
|
|
Listed below is the vehicle specific wiring diagram for your car alarm, remote starter or keyless entry installation into your 2007-2011 Hyundai Veracruz . This information outlines the wires location, color and polarity to help you identify the proper connection spots in the vehicle. Please be sure to test all of your wires with a digital multimeter before making any connections. More information on using a multimeter and testing wires please see our Technical Support Area.
|
|
|
 |
| PART |
COLOR |
LOCATION |
| 12 VOLT
CONSTANT |
RED (+) |
@ IGNITION SWITCH, (6-PIN PLUG), PIN 5 |
| STARTER |
GREEN (+) |
@ IGNITION SWITCH, (6-PIN PLUG), PIN 1 |
| STARTER
2 |
N/A |
|
| IGNITION
1 |
ORANGE (+) |
@ IGNITION SWITCH, (6-PIN PLUG), PIN 6 |
| IGNITION
2 |
N/A |
|
| IGNITION
3 |
N/A |
|
| ACCESSORY/HEATER
BLOWER 1 |
BLUE (+) |
@ IGNITION SWITCH, (6-PIN PLUG), PIN 3 |
| ACCESSORY/HEATER
BLOWER 2 |
YELLOW (+) |
@ IGNITION SWITCH, (6-PIN PLUG), PIN 4 |
| KEYSENSE |
N/A |
|
| PARKING
LIGHTS ( - ) |
ORANGE (-) |
@ BCM, (26-PIN PLUG), PIN 8, NOTE #2 |
| PARKING
LIGHTS ( + ) |
GREEN(+)(Left) and YELLOW(+)(Right) use both! |
@ DASH FUSE BOX, (GRAY, 39-PIN PLUG(D), PINS 11 and 24 |
| POWER LOCK |
NOTE #3 |
@ POWER WINDOW MAIN SWITCH, (23-PIN PLUG), PINS 16 and 14 |
| POWER UNLOCK |
NOTE #4 |
@ POWER WINDOW MAIN SWITCH, (23-PIN PLUG), PINS 17 and 14 |
| DOOR TRIGGER |
ORANGE (-) |
@ DASH FUSE BOX, (10-PIN PLUG(F), PIN 10 |
| DOMELIGHT
SUPERVISION |
BROWN (-) |
@ DASH FUSE BOX, (10-PIN PLUG(F), PIN 8 |
| TRUNK RELEASE |
GREEN/BLACK (-), without POWER TAILGATE, NOTE #5 |
@ BCM, (26-PIN PLUG), PIN 22, NOTE #2 |
| SLIDING
POWER DOOR |
N/A |
|
| HORN |
PINK or BLUE/BLACK (-) |
in DRIVERS KICK PANEL, (BLACK, 18-PIN PLUG), PIN 9 |
| TACH |
Any wire NOT ORANGE (AC) |
@ Any FUEL-INJECTOR |
| WAIT TO
START LIGHT |
N/A |
|
| BRAKE |
GREEN to GREEN/BLACK (+) |
@ BRAKE PEDAL SWITCH or in DRIVERS KICK PANEL, (WHITE, 14-PIN PLUG), PIN 12 |
| FACTORY
ALARM DISARM |
Use UNLOCK wires |
|
| ANTI-THEFT |
HYUNDAI'S TRANSPONDER ANTI-THEFT SYSTEM, See NOTE #1 |
@ IGNITION SWITCH TUMBLER |
| EXTRA
INFORMATION |
| NOTE #1: This vehicle May Be Equipped with HYUNDAI'S TRANSPONDER ANTI-THEFT SYSTEM,
check the OWNERS MANUAL for this vehcile or contact your HYUNDAI Dealer to see if
the vehicle has a Special programmed Ignition Key, if it does, then for REMOTE
STARTING you will need the 791 BYPASS Module and an Extra Ignition key.
To Order the 791 go to the SECURITY BYPASS MODULE Page on this website.
NOTE #2: the BCM, (Body Control Module) is located under the DRIVERS DASH.
NOTE #3: use both wires, the BROWN/ORANGE gets the (-) and the GRAY/BLACK must be
OPEN, TEST these wires while turning the KEY in the DRIVERS DOOR.
NOTE #4: use both wires, the PINK gets the (-) and the GRAY/BLACK (-), TEST these wires while
turning the KEY in the DRIVERS DOOR.
NOTE #5: on Vehicles with POWER TAILGATE, use the ORANGE (-), at the POWER LIFTGATE
SWITCH, (5-PIN PLUG), PIN 4
|
|
|
|
|
|
