Vehicle
Wiring Details for your
2007-2009 Saab 9-7X Wiring Diagram |
Printer Friendly
Version |
|
|
Listed below is the vehicle specific wiring diagram for your car alarm, remote starter or keyless entry installation into your 2007-2009 Saab 9-7X . This information outlines the wires location, color and polarity to help you identify the proper connection spots in the vehicle. Please be sure to test all of your wires with a digital multimeter before making any connections. More information on using a multimeter and testing wires please see our Technical Support Area.
|
|
|
 |
| PART |
COLOR |
LOCATION |
| 12 VOLT
CONSTANT |
ORANGE (+) 30 AMP |
@ TRAILER BRAKE PRE-WIRING HARNESS, NOTE #4 |
| STARTER |
YELLOW (+) |
@ IGNITION SWITCH, (BLACK, 12-PIN PLUG), PIN 11 |
| STARTER
2 |
N/A |
|
| IGNITION
1 |
PINK (+) |
@ IGNITION SWITCH, (BLACK, 12-PIN PLUG), PIN 5 |
| IGNITION
2 |
WHITE (+) |
@ IGNITION SWITCH, (BLACK, 12-PIN PLUG), PIN 10 |
| IGNITION
3 |
N/A |
|
| ACCESSORY/HEATER
BLOWER 1 |
ORANGE (+) |
@ IGNITION SWITCH, (BLACK, 12-PIN PLUG), PIN 7 |
| ACCESSORY/HEATER
BLOWER 2 |
BROWN (+) |
@ IGNITION SWITCH, (BLACK, 12-PIN PLUG), PIN 12 |
| KEYSENSE |
LT. GREEN (-), REQUIRED! |
@ IGNITION SWITCH, (BLACK, 12-PIN PLUG), PIN 4 or BCM, (TAN PLUG), PIN E3, NOTE #2 |
| PARKING
LIGHTS ( - ) |
BROWN/WHITE to GRAY/BLACK (-) |
@ HEADLIGHT Switch or BCM, (TAN PLUG), PIN E5, NOTE #2 |
| PARKING
LIGHTS ( + ) |
BROWN(+)(Left) and BROWN(+)(Right), use both and RELAY ISOLATE! |
@ REAR FUSE BOX, (BLACK, 68-PIN PLUG), PIN C3 and (WHITE, 68-PIN PLUG), PIN E2, NOTE #2 |
| POWER LOCK |
MUST use XK01 for KEYLESS ENTRY |
|
| POWER UNLOCK |
MUST use XK01 for KEYLESS ENTRY |
|
| DOOR TRIGGER |
GRAY/BLACK (-) |
@ DRIVERS WINDOW Switch, (GRAY, 24-PIN PLUG), PIN A2 |
| DOMELIGHT
SUPERVISION |
GRAY/BLACK (+) |
@ REAR FUSE BOX, (GRAY, 32-PIN PLUG), PIN B6, NOTE #3 |
| TRUNK RELEASE |
N/A |
|
| SLIDING
POWER DOOR |
N/A |
|
| HORN |
BLACK/YELLOW to BLACK (-) |
@ HORN Switch or BCM, (TAN PLUG), PIN E12, NOTE #2 |
| TACH |
Any wire NOT PINK (AC) |
@ Any FUEL-INJECTOR |
| WAIT TO
START LIGHT |
N/A |
|
| BRAKE |
WHITE to LT. BLUE (+) |
@ BRAKE PEDAL SWITCH or TRAILER BRAKE PRE-WIRING HARNESS, NOTE #4 |
| FACTORY
ALARM DISARM |
LT. GREEN (-) NOTE #5 |
@ DRIVERS WINDOW SWITCH, (GRAY, 24-PIN PLUG), PIN A4 |
| ANTI-THEFT |
SAAB'S TRANSPONDER ANTI-THEFT SYSTEM, Requires Bypass Module, See NOTE #1 |
@ IGNITION SWITCH TUMBLER |
| EXTRA
INFORMATION |
| NOTE #1: SAAB'S TRANSPONDER ANTI-THEFT SYSTEM, Requires Bypass Module,
MUST use XK01 Bypass Module for REMOTE START and KEYLESS ENTRY
NOTE #2: the BCM, (Body Control Module) is located under the LEFT REAR SEAT, attached to the
REAR FUSE BOX.
NOTE #3: the REAR FUSE BOX is located under the LEFT REAR SEAT.
NOTE #4: the TRAILER BRAKE PRE-WIRING HARNESS are 4 Blunt Cut wires on the HARNESS coming thru the DRIVERS FIREWALL.
NOTE #5: TEST this wire while TURNING the KEY in the DRIVERS DOOR.
|
|
|
|
|
|
