Vehicle
Wiring Details for your
2007-2009 Nissan Quest Wiring Diagram |
Printer Friendly
Version |
|
|
Listed below is the vehicle specific wiring diagram for your car alarm, remote starter or keyless entry installation into your 2007-2009 Nissan Quest . This information outlines the wires location, color and polarity to help you identify the proper connection spots in the vehicle. Please be sure to test all of your wires with a digital multimeter before making any connections. More information on using a multimeter and testing wires please see our Technical Support Area.
|
|
|
 |
| PART |
COLOR |
LOCATION |
| 12 VOLT
CONSTANT |
GREEN (+) 40 AMP |
@ IGNITION SWITCH, (WHITE, 6-PIN PLUG), PIN 3 |
| STARTER |
BLACK/RED (+) |
@ IGNITION SWITCH, (WHITE, 6-PIN PLUG), PIN 2 |
| STARTER
2 |
BLACK/YELLOW (+) |
@ IGNITION SWITCH, (WHITE, 6-PIN PLUG), PIN 6 |
| IGNITION
1 |
BLACK/WHITE (+) |
@ IGNITION SWITCH, (WHITE, 6-PIN PLUG), PIN 1 |
| IGNITION
2 |
N/A |
|
| IGNITION
3 |
N/A |
|
| ACCESSORY/HEATER
BLOWER 1 |
RED (+) |
@ IGNITION SWITCH, (WHITE, 6-PIN PLUG), PIN 4 |
| ACCESSORY/HEATER
BLOWER 2 |
WHITE/RED (+) |
@ IGNITION SWITCH, (WHITE, 6-PIN PLUG), PIN 5 |
| KEYSENSE |
N/A |
|
| PARKING
LIGHTS ( - ) |
N/A |
|
| PARKING
LIGHTS ( + ) |
RED/BLUE (+) |
in DRIVERS KICK PANEL, Harness to REAR of Vehicle |
| POWER LOCK |
BLUE (-), TYPE B, NOTE #3 |
@ POWER WINDOW Main Switch, (WHITE, 16-PIN PLUG), PIN 6 or 4 |
| POWER UNLOCK |
RED (-), TYPE B, Requres Double Pulse, NOTE #4 |
@ POWER WINDOW Main Switch, (WHITE, 16-PIN PLUG), PIN 7 or 6 |
| DOOR TRIGGER |
GRAY/RED (-) |
in DRIVERS KICK PANEL or BCM, (WHITE, 15-PIN PLUG), PIN 7, NOTE #2 |
| DOMELIGHT
SUPERVISION |
PINK (-) |
@ BCM, (BLACK, 15-PIN PLUG), PIN 8, NOTE #2 |
| TRUNK RELEASE |
GREEN/RED (-) (Power Liftgate) |
@ DRIVERS A Pillar or DRIVERS KICK PANEL, Harness to REAR of Vehicle |
| SLIDING
POWER DOOR |
BLUE/WHITE (-) |
@ DRIVERS A Pillar or DRIVERS KICK PANEL, Harness to REAR of Vehicle |
| HORN |
GREEN/WHITE (-) |
@ HORN Switch, (GRAY 8-PIN PLUG), PIN 2, under Steering Column Cover |
| TACH |
Any wire NOT RED (AC) |
@ Any FUEL-INJECTOR |
| WAIT TO
START LIGHT |
N/A |
|
| BRAKE |
RED/GREEN (+) |
@ BRAKE PEDAL Switch or in DRIVERS KICK PANEL, Harness to REAR of Vehicle |
| FACTORY
ALARM DISARM |
Use UNLOCK wire |
|
| ANTI-THEFT |
NISSAN'S TRANSPONDER ANTI-THEFT SYSTEM, Requires Bypass Module, See NOTE #1 |
|
| EXTRA
INFORMATION |
| NOTE #1: NISSAN'S TRANSPONDER ANTI-THEFT SYSTEM, Requires Bypass Module,
Part # 791 (For REMOTE START ONLY)
Part # DLPK-CANBUS MULTI (for REMOTE START and DOOR LOCKS)
NOTE #2: the BCM (Body Control Module) is located under the Drivers Dash and ABOVE
the Drivers Kick Panel.
NOTE #3: TEST this wire while Turning the KEY in the Drivers Door. This wire will also ARM the
FACTORY ALARM.
NOTE #4: TEST this wire while Turning the KEY in the Drivers Door. This wire will also DISARM the
FACTORY ALARM.
|
|
|
|
|
|
