Vehicle
Wiring Details for your
2007-2009 Audi Q7 Wiring Diagram |
Printer Friendly
Version |
|
|
Listed below is the vehicle specific wiring diagram for your car alarm, remote starter or keyless entry installation into your 2007-2009 Audi Q7 . This information outlines the wires location, color and polarity to help you identify the proper connection spots in the vehicle. Please be sure to test all of your wires with a digital multimeter before making any connections. More information on using a multimeter and testing wires please see our Technical Support Area.
|
|
|
 |
| PART |
COLOR |
LOCATION |
| 12 VOLT
CONSTANT |
RED (+) |
@ DRIVERS DASH FUSE PANEL, (FUSE HOLDER 1), PIN 6 |
| STARTER |
See NOTE #1 |
|
| STARTER
2 |
N/A |
|
| IGNITION
1 |
BLACK (+) (for IGNITION Sense Only!) |
@ DRIVERS DASH FUSE PANEL, (FUSE HOLDER 3), PIN 6 |
| IGNITION
2 |
N/A |
|
| IGNITION
3 |
N/A |
|
| ACCESSORY/HEATER
BLOWER 1 |
BLACK/YELLOW (+) (for ACCESSORY Sense Only!!) |
@ CENTER DASH RELAY and FUSE PANEL |
| ACCESSORY/HEATER
BLOWER 2 |
N/A |
|
| KEYSENSE |
N/A |
|
| PARKING
LIGHTS ( - ) |
N/A |
|
| PARKING
LIGHTS ( + ) |
GRAY/BLACK(+)(Left Front) and GRAY/RED(+)(Right Front), NOTE #3 |
@ VESCM, (32-PIN PLUG), PINS 4 and 15, NOTE #2 |
| POWER LOCK |
PURPLE/RED (-) thru a Resistor, (Measure) |
@ DRIVERS DOOR CONTROL MODULE, (32-PIN PLUG), PIN 28 |
| POWER UNLOCK |
Use LOCK wire (-) thru a Resistor (Measure) |
|
| DOOR TRIGGER |
GRAY/PURPLE (-) |
@ DRIVERS DOOR CONTROL MODULE, (20-PIN PLUG), PIN 5 |
| DOMELIGHT
SUPERVISION |
BROWN/BLUE (-) |
@ CSCM, (15-PIN PLUG), PIN 14, NOTE #4 |
| TRUNK RELEASE |
RED/GREEN (-) |
@ DRIVERS DOOR CONTROL MODULE, (32-PIN PLUG), PIN 23 |
| SLIDING
POWER DOOR |
N/A |
|
| HORN |
BLACK/WHITE (+) |
@ VESCM, (32-PIN PLUG), PIN 17, NOTE #2 |
| TACH |
Any wire with a BROWN STRIPE, (AC) |
@ Any FUEL-INJECTOR |
| WAIT TO
START LIGHT |
N/A |
|
| BRAKE |
BLACK/RED (+) |
@ BRAKE PEDAL SWITCH, (4-PIN PLUG), PIN 3 |
| FACTORY
ALARM DISARM |
BLUE/WHITE (-) thru a Resistor (Measure), NOTE #5 |
@ DRIVERS DOOR CONTROL MODULE, (20-PIN PLUG), PIN 1 |
| ANTI-THEFT |
AUDI'S TRANSPONDER ANTI-THEFT SYSTEM, See NOTE #1 |
@ IGNITION SWITCH TUMBLER |
| EXTRA
INFORMATION |
| NOTE #1: AUDI'S TRANSPONDER ANTI-THEFT SYSTEM, Requires Bypass Module,
DUE to the SPECIAL IGNITION Circuit on this Vehicle, MUST USE:
Part # CANMAX 400 Bypass/Interface Module
NOTE #2: the VESCM, (Vehicle Electronic System Control Module) is located,
UNDER the DRIVERS DASH.
NOTE #3: the LEFT REAR Parking light is GRAY/BLACK(+) and the RIGHT REAR Parking light is a
GRAY/RED(+) at the Comfort System Contol Module, (15-PIN PLUG), PIN 1 and
(15-PIN PLUG), PIN 7 use all 4 WIRES and ISOLATE
NOTE #4; the CSCM, (Comfort System Control Module) is located on the RIGHT side of the
LUGGAGE Compartment.
NOTE #5: TEST this wire while Turning the KEY in the DRIVERS DOOR, this wire also UNLOCKS
the doors.
|
|
|
|
|
|
