Vehicle
Wiring Details for your
2007-2008 Volkswagen Eos Wiring Diagram |
Printer Friendly
Version |
|
|
Listed below is the vehicle specific wiring diagram for your car alarm, remote starter or keyless entry installation into your 2007-2008 Volkswagen Eos . This information outlines the wires location, color and polarity to help you identify the proper connection spots in the vehicle. Please be sure to test all of your wires with a digital multimeter before making any connections. More information on using a multimeter and testing wires please see our Technical Support Area.
|
|
|
 |
| PART |
COLOR |
LOCATION |
| 12 VOLT
CONSTANT |
RED (+), 50 AMP |
@ FUSE BOX, (PIN 38), NOTE #2 |
| STARTER |
RED/BLACK (+) |
@ VESCM, (12-PIN PLUG(G), PIN 1, NOTE #3 |
| STARTER
2 |
N/A |
|
| IGNITION
1 |
BLACK (+) |
@ VESCM, (12-PIN PLUG(G), PIN 11, NOTE #3 |
| IGNITION
2 |
N/A |
|
| IGNITION
3 |
N/A |
|
| ACCESSORY/HEATER
BLOWER 1 |
N/A |
|
| ACCESSORY/HEATER
BLOWER 2 |
N/A |
|
| KEYSENSE |
N/A |
|
| PARKING
LIGHTS ( - ) |
N/A |
|
| PARKING
LIGHTS ( + ) |
GRAY/YELLOW (+) |
@ HEADLIGHT SWITCH or VESCM, (16-PIN PLUG(E), PIN 1, NOTE #3 |
| POWER LOCK |
BROWN/GREEN (-), NOTE #4, See DIAGRAM |
@ DDCM, (20-PIN PLUG), PIN 32, NOTE #5 |
| POWER UNLOCK |
Use LOCK wire, (-) thru a 250 Ohm Resistor to UNLOCK |
|
| DOOR TRIGGER |
BROWN/YELLOW (-) |
@ DDCM, (20-PIN PLUG), PIN 7, NOTE #5 |
| DOMELIGHT
SUPERVISION |
RED/PURPLE (-) |
@ VESCM, (12-PIN PLUG(B), PIN 11, NOTE #3 |
| TRUNK RELEASE |
PURPLE (-) |
@ CSCCM, (8-PIN PLUG), PIN 6, NOTE #6 |
| SLIDING
POWER DOOR |
N/A |
|
| HORN |
BLACK/WHITE (+) |
@ VESCM, (16-PIN PLUG(J), PIN 6, NOTE #3 |
| TACH |
NOTE #7 |
@ Any FUEL-INJECTOR |
| WAIT TO
START LIGHT |
N/A |
|
| BRAKE |
BLACK/RED (+) |
@ BRAKE PEDAL SWITCH or VESCM, (16-PIN PLUG(E), PIN 2, NOTE #3 |
| FACTORY
ALARM DISARM |
NOTE #8 |
@ DDCM, (20-PIN PLUG), PIN 16, NOTE #5 |
| ANTI-THEFT |
VW'S TRANSPONDER ANTI-THEFT SYSTEM, Requires Bypass Module, See NOTE #1 |
@ IGNITION SWITCH TUMBLER |
| EXTRA
INFORMATION |
| NOTE #1: VW'S TRANSPONDER ANTI-THEFT SYSTEM, Requires Bypass Module,
Part # 791 Bypass Module, for REMOTE STARTING ONLY!
Part # DLPK-CANBUS MULTI for REMOTE STARTING and DOOR LOCKS (Resistors for
DOOR LOCKS, NOT REQUIRED)
NOTE #2: the FUSE BOX is located at the LEFT END of th DRIVERS DASH.
NOTE #3: the VESCM, (Vehicle Electrical System Control Module) is the RELAY BOX, Under
the DRIVERS DASH.
NOTE #4: this vehicle uses a 1-WIRE DOOR LOCKING SYSTEM, that Requires Extra Parts for
operation. See DIAGRAM. The use of Bypass Module DLPK-CANBUS MULTI will do the
ANTI-THEFT and DOOR LOCKS without the use of relays and resistors.
NOTE #5: the DDCM, (Drivers Door Control Module) is located in the DRIVERS DOOR.
NOTE #6: the CSCCM, ( Comfort System Central Control Module) is located behind the
GLOVE BOX.
NOTE #7: when using the TACH wire, use any wire NOT with a RED STRIPE(2.0T Engine)
or a RED/BLACK(3.2 Engine) both test (AC)
NOTE #8: to DISARM FACTORY ALARM (if needed) Requires a (-) thru a 250 Ohm Resistor on
the GREEN/WHITE (-) wire, requires resistor and relay. TEST this wire while turning the
KEY in the DRIVERS DOOR.
|
|
|
|
|
|
