Vehicle
Wiring Details for your
2007-2008 Suzuki Xl-7 Wiring Diagram |
Printer Friendly
Version |
|
|
Listed below is the vehicle specific wiring diagram for your car alarm, remote starter or keyless entry installation into your 2007-2008 Suzuki Xl-7 . This information outlines the wires location, color and polarity to help you identify the proper connection spots in the vehicle. Please be sure to test all of your wires with a digital multimeter before making any connections. More information on using a multimeter and testing wires please see our Technical Support Area.
|
|
|
 |
| PART |
COLOR |
LOCATION |
| 12 VOLT
CONSTANT |
RED/BLACK(+), RED/BLACK(+) 50 AMP |
@ FUSE BOX, (LT. GRAY, 6-PIN PLUG), PINS 1 and 3 |
| STARTER |
YELLOW (+) (NOT for REMOTE STARTING), NOTE #1 |
@ ECM, (BLACK PLUG) PIN 52, NOTE #4 |
| STARTER
2 |
WHITE (+) thru a 9.6K Ohm Resistor, NOTE #1 |
@ IGNITION SWITCH or BCM, (LT. GREEN PLUG), PIN 2, NOTE #2 |
| IGNITION
1 |
PINK (+) |
@ IGNITION SWITCH or BCM, (LT. GREEN PLUG), PIN 14, NOTE #2 |
| IGNITION
2 |
N/A |
|
| IGNITION
3 |
N/A |
|
| ACCESSORY/HEATER
BLOWER 1 |
BROWN (+) |
@ IGNITION SWITCH or BCM, (LT. GREEN PLUG), PIN 21, NOTE #2 |
| ACCESSORY/HEATER
BLOWER 2 |
Use STARTER 2 (+) thru a 6.3K Ohm Resistor, NOTE #1 |
|
| KEYSENSE |
N/A |
|
| PARKING
LIGHTS ( - ) |
BROWN/WHITE (-) |
@ HEADLIGHT SWITCH or BCM, (WHITE PLUG), PIN 8, NOTE #2 |
| PARKING
LIGHTS ( + ) |
PURPLE(+)(Left) and BROWN/WHITE(+)(Right) |
@ UNDER HOOD FUSE BOX, (BLACK PLUG), PINS 22 and 12 |
| POWER LOCK |
PINK/BLACK(-), TYPE B |
in DRIVERS KICK PANEL or BCM, (GRAY PLUG), PIN 12, NOTE #2 |
| POWER UNLOCK |
ORANGE/BLACK(-), TYPE B |
in DRIVERS KICK PANEL or BCM, (GRAY PLUG), PIN 11, NOTE #2 and #5 |
| DOOR TRIGGER |
GRAY/BLACK (-) |
in DRIVERS KICK PANEL or BCM, (PINK PLUG), PIN 10, NOTE #2 |
| DOMELIGHT
SUPERVISION |
DK. BLUE/WHITE (+) |
@ BCM, (PINK PLUG), PIN 1, NOTE #2 |
| TRUNK RELEASE |
GRAY (-), NOTE #3 |
@ BCM, (PINK PLUG), PIN 15, NOTE #2 |
| SLIDING
POWER DOOR |
N/A |
|
| HORN |
TAN (-) |
@ HORN SWITCH or BCM, (BROWN PLUG), PIN 18, NOTE #2 |
| TACH |
Any wire NOT PINK or PINK/BLACK (AC) |
@ Any FUEL-INJECTOR |
| WAIT TO
START LIGHT |
N/A |
|
| BRAKE |
LT. BLUE (+) |
@ BCM, (BROWN PLUG), PIN 5, NOTE #2 |
| FACTORY
ALARM DISARM |
DISARMS with FACTORY REMOTE ONLY!! |
|
| ANTI-THEFT |
SUZUKI'S TRANSPONDER ANTI-THEFT SYSTEM, Requires Bypass Module, Part # PKUGM2X, See NOTE #1 |
@ IGNITION SWITCH TUMBLER |
| EXTRA
INFORMATION |
| NOTE #1: this Vehicle Requires a Bypass Part # PKUGM2X , PKUMUX,or CANMAX 400 Bypass Module for REMOTE STARTING.(RESISTORS NOT REQUIRED) To purchase bypass ,Google part number and click shopping.
NOTE #2: the BCM, (Body Control Module) is located in the CENTER CONSOLE, below the Radio.
NOTE #3: TEST this wire while Opening the LIFTGATE from the handle on the REAR of the
Vehicle.
NOTE #4: the ECM, (Engine Control Module) is located in the ENGINE COMPARTMENT, behind the
Drivers Side Headlight.
NOTE #5: to UNLOCK just the DRIVERS DOOR, use a YELLOW(-), @ BCM, (GRAY PLUG), PIN 6
|
|
|
|
|
|
