Vehicle
Wiring Details for your
2007-2008 Isuzu I-290 Wiring Diagram |
Printer Friendly
Version |
|
|
Listed below is the vehicle specific wiring diagram for your car alarm, remote starter or keyless entry installation into your 2007-2008 Isuzu I-290 . This information outlines the wires location, color and polarity to help you identify the proper connection spots in the vehicle. Please be sure to test all of your wires with a digital multimeter before making any connections. More information on using a multimeter and testing wires please see our Technical Support Area.
|
|
|
 |
| PART |
COLOR |
LOCATION |
| 12 VOLT
CONSTANT |
Connwct DIRECTLY ot BATTERY!! |
|
| STARTER |
PURPLE (+) (NOT for REMOTE STARTING!!), NOTE #1 |
@ STARTER or UNDERHOOD FUSE BOX, (BLACK PLUG), PIN E2 |
| STARTER
2 |
WHITE/BLUE to WHITE (MUX), NOTE #1 |
@ IGNITION SWITCH, (PIN 4) or BCM, (GRAY PLUG), PIN A14, NOTE #2 |
| IGNITION
1 |
WHITE/GREEN to DK. BLUE (+), NOTE #1 |
@ IGNITION SWITCH, (PIN 3) or BCM, (GRAY PLUG), PIN B8, NOTE #2 |
| IGNITION
2 |
N/A |
|
| IGNITION
3 |
N/A |
|
| ACCESSORY/HEATER
BLOWER 1 |
WHITE/RED to BROWN (+), NOTE #1 |
@ IGNITION SWITCH, (PIN 1) or BCM, (GRAY PLUG), PIN B7, NOTE #2 |
| ACCESSORY/HEATER
BLOWER 2 |
N/A |
|
| KEYSENSE |
N/A |
|
| PARKING
LIGHTS ( - ) |
BROWN/WHITE (-) |
@ HEADLIGHT SWITCH or BCM, (GRAY PLUG), PIN A7, NOTE #2 |
| PARKING
LIGHTS ( + ) |
BROWN (+) |
@ BCM, (BLACK PLUG), PIN A48, NOTE #2 |
| POWER LOCK |
LT. BLUE (-), TYPE B |
in EITHER KICK PANEL or BCM, (BLACK PLUG), PIN A11, NOTE #2 |
| POWER UNLOCK |
DK. BLUE (-), TYPE B, NOTE #3 |
in EITHER KICK PANEL at DOOR HARNESS |
| DOOR TRIGGER |
GRAY/BLACK (-) |
@ BCM, (BLACK PLUG), PIN A32, NOTE #2 |
| DOMELIGHT
SUPERVISION |
WHITE (-) |
@ BCM, (BLACK PLUG), PIN A46, NOTE #2 |
| TRUNK RELEASE |
N/A |
|
| SLIDING
POWER DOOR |
N/A |
|
| HORN |
GREEN to BLACK (-) |
@ HORN SWITCH or BCM, (GRAY PLUG), PIN A25, NOTE #2 |
| TACH |
Any wire NOT PINK or BLACK, (AC) |
@ Any IGNITION COIL or FUEL-INJECTOR |
| WAIT TO
START LIGHT |
N/A |
|
| BRAKE |
LT. BLUE (+) |
@ BRAKE PEDAL SWITCH |
| FACTORY
ALARM DISARM |
DISARMS with FACTORY REMOTE ONLY!! |
|
| ANTI-THEFT |
GM'S (ION TYPE) PASSLOCK 2 ANTI-THEFT SYSTEM, Requires Bypass Module, See NOTE #1 |
@ IGNITION SWITCH HARNESS |
| EXTRA
INFORMATION |
| NOTE #1: REQUIES SPECIAL BYPASS MODULE for REMOTE STARTING: Use a PLXR, PLJX, or an XK06 with PLXR 3.00 firmware. If you use a CANMAX 400 with 400.GM5 0.13 firmware, this will, in addition to remote start, also operate door locks and factory alarm.
NOTE #2: the BCM (Body Control Module) is located in the PASSENGER KICK PANEL.
NOTE #3: to UNLOCK just the DRIVERS DOOR, use the WHITE (-) at the BCM, (BLACK PUG), PIN A12.
|
|
|
|
|
|
